Rane CP R1 Installation Manual

INSTALLATION  MANUAL

CP R1 & CP R2

REMOTE CONTROLS FOR CP 62

Two Paging Sources

with No CP R1 Remote Control

When using both paging inputs but not the CP R1 remote

you do need to plug in and set the configuration adapter, (the

short piece of wire with the phone plug and stripped wires

included with the CP 62.) This adapter tells the CP 62 where

one of the paging sources needs to go. The front panel

PAGING ZONE ASSIGN switch (see Front Panel, balloon

#6) routes one paging source and the configuration adapter

routes the other.

Setting the CONFIGURATION ADAPTER:

To page only in ZONE 1 twist the black and green wires

together.

To page only in ZONE 2 twist the black and red wires

together.

To page in BOTH Zones twist all three (black, red, and

green) together.

Ignore the cowardly yellow wire, it serves no purpose.

CP R1 Zone Assign Remote

Control

When installing the R1 Remote, locate it next to the

paging source. This lets the user select the zones where the

page is to be heard. The R1 connects to the REMOTE ZONE

ASSIGN jack next to the paging inputs on the rear of the

CP 62.

CP R1 with One Paging Source:

Either Mic or Phone/Line

The front panel PAGING ZONE ASSIGN switch (see

Front Panel, balloon #6) lets you assign the paging signal to

ZONE 1, BOTH or ZONE 2. Similarly, the CP R1 remote lets

you assign one of the Paging Sources to either or both Zones.

Which signal is controlled from the front panel PAGING

ZONE ASSIGN switch and which is controlled via the rear

panel REMOTE ZONE ASSIGN connector (Rear Panel,

balloon #15) is determined by the rear panel PAGING

INPUTS ASSIGN switch (see Rear Panel, balloon #4). The

rear panel switch controls the front panel switch and the rear

panel connector.

 To use only one paging signal and control it from the

front panel of the CP 62: set the rear panel PAGING INPUTS

ASSIGN switch to PHONE to control the PHONE/LINE

signal from the front panel of the CP 62, or to MIC to control

the MIC signal from the front panel.

 Use the CP R1 remote to control one paging source from

another location. In this scenario, set the rear panel PAGING

INPUTS ASSIGN switch to MIC to control the XLR MIC

signal via the remote or set the switch to PHONE/LINE to

control the PHONE/LINE signal from the CP R1 remote.

CP R1 with Two Paging Sources:

Both Mic and Phone/Line)

When using both paging sources, the rear panel PAGING

INPUTS ASSIGN switch controls two functions (see Rear

Panel, balloon #4). Which signal is controlled from the front

panel PAGING ZONE ASSIGN switch (see Front Panel,

ballon #6) and which signal is controlled by the REMOTE

ZONE ASSIGN connector (Rear Panel, balloon #15, the place

you plug in the CP R1 remote.)

To use the CP R1 remote to control the XLR MIC signal

set the rear panel PAGING INPUTS ASSIGN switch to the

MIC position. To control the PHONE/LINE signal, set the

PAGING INPUTS ASSIGN switch to the PHONE/LINE

position.

See the CP 62 Manual for operating instructions.