Da216s distribution amplifier.
Risk of electric shock do not open caution to reduce the risk of electrical shock, do not open the unit. No user serviceable parts inside. Refer servicing to qualified service personnel. The symbols shown below are internationally accepted symbols that warn of potential hazards with electrical produ...
Manual-1 da216s distribution amplifier operators manual quick start this section is for those that just can’t wait to get started. This distribution amplifier has a powerful feature not found on most da’s – output assignment switches. If your application calls for a single channel set-up with one in...
Manual-2 da216s front panel 1 master levels: these screwdriver adjustable controls set the level of each input to be routed to bus a, b, or a+b. The overload (ol) leds illuminate whenever either input section (both pre-gain and post-gain) approach clipping. Each master level may be adjusted from off...
Manual-3 da216s rear panel 1 input euroblocks: attach either microphone or line-level sources here. Euroblocks accept any #14 to #26 guage wire. Connect balanced sources to the respective “+” and “–”terminals, and tie the shield to chassis ground. For unbalanced sources use two-conductor shielded ca...
Manual-4 ©rane corporation 10802 47th ave. W., mukilteo wa 98275-5000 usa tel 425-355-6000 fax 425-347-7757 web rane.Com operating instructions using the 3-position output assign switches, select either the a input, the b input, or a+b inputs. If the sum of both inputs is selected, but only one inpu...
