Rane MA 6S Operator's Manual

Other manuals for MA 6S: Operator's Manual, Operator's Manual

Summary of MA 6S

  • Page 1

    Ma 6s multichannel amplifier power 3 6 5 4 2 level 1 power thermal clip limit clip limit clip limit clip limit clip limit clip limit soa limit soa limit soa limit soa limit soa limit soa limit ready ready ready ready ready ready 10 0 2 4 8 6 level 10 0 2 4 8 6 level 10 0 2 4 8 6 level 10 0 2 4 8 6 l...

  • Page 2

    Risk of electric shock do not open caution to reduce the risk of electrical shock, do not open the unit. No user serviceable parts inside. Refer servicing to qualified service personnel. The symbols shown below are internationally accepted symbols that warn of potential hazards with electrical produ...

  • Page 3

    Manual-1 operators manual ma 6s multichannel amplifier quick start you gots your good habits, and you gots your bad habits. A good habit is to read at least this much of the manual. A bad habit is not to read any of this manual. Reading just this section can prevent grief worse than your worst night...

  • Page 4

    Manual-2 front panel description power switch: obediently turns the ma 6s on and off every time you poke it with your finger (or other suitable object). All six channels have delayed turn-on/instant turn-off relays to eliminate any switching transients. Thermal overload indicator: lights red if the ma ...

  • Page 5

    Manual-3 rear panel description inputs: these are balanced euroblock connectors. Cable should include two wires with shield. Euroblocks accept up to 12 awg wire. The shield may be attached to either chassis or signal ground. For unbalanced sources consult the included ranenote, “sound system interco...

  • Page 6

    Manual-4 ma 6s connections direct, biamp, and bridged wiring ma 6s acn 001 345 482 made in u.S.A. Rane corp. Warning to reduce the risk of fire or electrical shock do not expose this equipment to rain or moisture. Do not remove cover. No user serviceable parts inside. Refer servicing to qualified pe...

  • Page 7

    Manual-5 the ma 6s will drive an active two-way stereo system when wired as shown. The high frequency drivers run direct from channels 5 and 6. The low frequency drivers, requiring much more power, are run from two bridged pairs: channels 1 and 2 are bridged to one woofer, and channels 3 and 4 are b...

  • Page 8

    Manual-6 ©rane corporation 10802 47th ave. W., mukilteo wa 98275-5098 tel 425-355-6000 fax 425-347-7757 web www.Rane.Com operation voltage controlled attenuators the voltage controlled attenuators (vcas) in the ma 6s allow a significant increase in usable volume levels without exces- sive clipping or...