Rane MLM 82S Operator's Manual - page 3
Manual-
REAR PANEL DESCRIPTION
1
MIC/LINE INPUTS 1 through 4.
These XLRs connect either balanced Microphone or Line signals, depending on the LINE
switch setting (see 3). Rane adheres to the international and U.S. standard for balanced pin configurations: Pin 1 is chassis
ground (neutral), pin 2 is positive (+), and pin 3 is negative (–).
2
PHANTOM POWER switch
applies 15 V Phantom Power to any Inputs 1-4 that are set for MIC Input.
3
LINE Input selectors
switch the sensitivity and input impedance for either a microphone or line level input. If LINE is chosen,
Phantom Power is deactivated for that Input.
4
¼" LINE INPUTS.
These stereo pairs of balanced inputs accommodate stereo line-level signals. These TRS (Tip-Ring-Sleeve) ¼"
jacks handle either balanced or unbalanced signals. In most cases an unbalanced signal may use a mono ¼" plug (Tip-Sleeve). See
the Sound System Interconnection RaneNote included with this manual for proper connection.
5
A and B OUTPUT jacks.
These balanced XLR’s provide the A and B mixed output. INTERNAL OUTPUT LEVEL switches
allow setting the output level for MIC or LINE level. Pin connections are the same as above in 1.
6
Power connector:
The internal universal switching power supply operates on any AC mains 100 to 240 VAC, 50 or 60 Hz (most
places in the world). All that is required when traveling is the appropriate IEC line cord.
6
2
3
5
1
4
B
LINE
MADE IN
U.S.A.
RANE
CORP.
A
LINE
LINE
LINE
PHANTOM
POWER
MLM 82S
5
B
A
6
B
A
7
B
A
8
A
B
OUTPUTS
1
3
4
2
LINE INPUTS
MIC / LINE INPUTS
BALANCED: PIN 3 = (–), PIN 2 = (+), PIN 1 = (G)
100-240 V
50/60 Hz 7 WATTS
ACN 001
345 482
COMMERCIAL AUDIO
EQUIPMENT 24TJ
R
THIS DEVICE
COMPLIES WITH
PART 15 OF THE
FCC RULES FOR
A CLASS 'B'
COMPUTING
DEVICE.