Rane MM 12 Operator's Manual

Manual is about: mixer

Summary of MM 12

  • Page 1

    1. Warranty explanation rane offers a limited warranty which covers both parts and labor necessary to repair any defects in the manufacturing of the mm 12. The warranty period for the mm 12 is two (2) years, and is determined from either of these two methods, whichever is longer: l. Starting from th...

  • Page 2

    Ii. Front panel description.

  • Page 3

    1. Power switch: the adjacent yellow led will light when power to the mm 12 is turned on by means of this switch. 2. Inputs: these automatic balanced/unbalanced three-pin jacks are to be used for both microphone or line level inputs. Rane adheres to the international standard pin configuration. Whic...

  • Page 4

    12. Headphone level: this knob controls volume in the headphones. The mm 12 will handle headphones with impedances between 8 ohms and 2000 ohms. 13. Overload indicator: this red led will light whenever the output level reaches 4 db below clipping which is +15 dbm output level. 14. Cue button: press ...

  • Page 5

    Iii. Installation this section provides simplified diagrams indicating recommended wiring configurations for installation of the mm 12 into your sound reinforcement system. There are, of course, many other applications or configurations in which the mm 12 will work well, and we encourage you to modi...

  • Page 7

    Diagram iil-2. Stage location of the mm 12 for dedicated monitor mix operator 1. Run a short snake from a stage box to the inputs of the mm 12; this snake need only be long enough to reach from center stage to the mm 12 location, but is is wise to make it long enough to run it along the edge of the ...

  • Page 10

    Iv-l. Input assignments a. Submlxing multiple instruments. The mm 12 has 12 inputs but only 8 monitor mix level controls above each output master level. The reason for this is to simplify monitor mixing by doing some clever sub-mixing on the inputs. Most groups possess at least one individual who pl...

  • Page 11

    2. Set both bass and treble boost/cut knobs to the ”0” center detent position, and both bandwidth buttons to the nar (in) position. 3. Slowly turn up both the #1 master level and the mix level knob in column 1 for the microphone located next to monitor 8 on stage: turn up both level controls until f...

  • Page 12

    Set of headphones into the mm 12 to monitor both the house mix and the monitor mixes as necessary. Whenever any of the mm 12 cue buttons is depressed, you will hear the mix in that monitor. When none of the mm 12 cue buttons are depressed, you wiii automatically hear the house mix from the main mixe...

  • Page 13

    V. Specifications 12 inputs with the following: -transformerless electronically balanced/unbalanced female three-pin connector input. -passive mic splitter with male three-pin connector output. -built-in rfi filters. -input impedance: 8k ohms in mic or line. -active gain control: 20 db to 70 db in m...