Rpm 26z programmable multiprocessor inpu t aes3 outpu t 12 ab 1 43 2 6 5 lock vip po w er ethernet st atus rpm 26z programmable m ul tiprocesso r preset 24.
Risk of electric shock do not open caution to reduce the risk of electrical shock, do not open the unit. No user serviceable parts inside. Refer servicing to qualified service personnel. The symbols shown below are internationally accepted symbols that warn of potential hazards with electrical produ...
Manual-1 rpm 26z programmable multiprocessor hardware manual wear parts: this product contains no wear parts. Quick start this section is intended to help you make the physical connec- tions and software manipulations necessary to get up and run- ning with your sleek new rpm 26z. If you don’t read t...
Manual-2 rear panel description front panel description 1 signal/overload led meters indicate the presence of significant audio signal or overload for inputs and outputs. These 3-color meters indicate the available headroom once the analog signal has been converted to digital: -4 dbfs (red, near cli...
Manual-3 audio connections for each input or output euroblock connector: • connect the (positive) audio line to the ‘+’ terminal. • connect the (negative) audio line to the ‘–’ terminal. • connect the cable shield to the ground terminal. For those installations where the rpm 26z’s internal shield- t...
Manual-4 remote level control using potentiometers the vip inherently prefers linear taper 10 kΩ potentiometers, which provide a nice audio taper “feel” for the end user. When used with suitable twisted pair wiring, the 10 kΩ value also of- fers acceptable noise immunity and very long cable lengths....
Drag net quick start-1 drag net quick start rane’s tradition of writing a one page quick start section in our manuals has been revamped. Since this section is four pages, it’s called the mostly quick start section. Drag net software installation is straight forward — just run the setup.Exe file incl...
Drag net quick start-2 the remote map is used to configure the versatile input port (vip) and the rw-485 remote interface port, if the rpm unit is so equipped. The vip accepts either contact closure switches for preset recall, or 0-5v potentiometer-on-a-wall devices for level control. Double-click e...
Drag net quick start-3 the resource window displays usage information specific to the hardware device you're working with. The dsp usage meter indicates the amount of dsp "horsepower" used by the current configuration, and is always accurate. There is no need to hit a “compile” button, since drag ne...
Drag net quick start-4 ©rane corporation 10802 47th ave. W., mukilteo wa 98275-5098 usa tel 425-355-6000 fax 425-347-7757 web www.Rane.Com 106405 big picture concepts storage mode versus live mode when you first create a drag net device configuration, it is stored and appears under the storage folde...
