Rane SP 13 Operator's Manual - page 2
Manual-2
FRONT PANEL DESCRIPTION
Stick® INSTRUMENT INPUT:
is a stereo ¼" TRS (Tip-Ring-Sleeve) INPUT jack for use with a Stick instrument with
two pickups; Use a balanced or stereo ¼" shielded cable to connect your instrument to this Input. However, this also accepts
a mono input. When using a mono cable, signal is routed to the TIP selected by the Input Wiring Switch (see
).
A & B Input OVERLOAD indicators:
are useful in monitoring pickup level and initially in setting PICKUP GAIN TRIM
controls. These indicators light approximately 4 dB before actual clipping, so occasional flickering is okay, but they should
never be allowed to light steadily.
Input wiring switch:
allows choice of Input wiring. Either TIP=A and RING=B, or vice-versa.
Input INSTRUMENT GAIN trims:
set the proper Gain for each pickup. Range is from 6 dB minimum to 60 dB maxi-
mum.
INVERT switches:
Invert the polarity (phase) of the A pickup with respect to the B pickup. Either A or B PICKUPS may
be individually Inverted.
LOW CUT frequency:
adjusts the corner frequency of the LOW CUT (high-pass) filter from 15 Hz to 250 Hz. Use to
reduce unwanted low frequencies in either A or B Pickups.
7-band graphic equalizer boost/cut controls:
set the amount of boost/cut for each of the indicated bands in both Pickups
A and B. A grounded center detent guarantees flat response for filters not used.
PICKUP A OUT control:
adjusts the level of the AUX OUTPUT jack. This Output is independent of the LEVEL and
MAIN OUT LEVEL controls.
PAN controls:
for both PICKUPS A and B allow signal routing anywhere between MAIN OUT A and B.
LEVEL controls:
for both PICKUPS A and B set the overall Level of each signal.
SEND A/B controls:
adjust the amount of signal at each of the SEND jacks (to external signal processing).
RETURN control:
is a “stereo” Return. Controls the amount of
A and B
entering the RETURN jacks.
MAIN OUT MUTE button:
cuts off the signal to both A and B Main Outputs. Does
not
affect the Headphone Output. The
red LED indicates Muted Output.
MAIN OUT A & B LEVELS:
are concentric controls used to separately set the Main A & B Output Levels.
MAIN OUT OVERLOAD indicator:
monitors
both
A and B Main Outputs. An overload condition (within 4 dB of
clipping) on
either
Output causes this red indicator to light.
HEADPHONE LEVEL:
controls the volume of the HEADPHONE Output jack.
POWER indicator:
glows yellow when the proper power supply is connected and powered.
Headphone jack:
Accepts standard stereo headphones rated from 32-600 ohms equipped with a ¼" TRS plug.