Summary of TTM 56
Page 1
Ttm 56 performance mixer.
Page 2
Important safety instructions for the continued safety of yourself and others we recommend that you read the following safety and installation instructions. Keep this document in a safe location for future reference. Please heed all warnings and follow all instructions. Do not use this equipment in ...
Page 3
Manual- ttm 56 performance mixer operators manual quick start congratulations! You are the proud owner of an exceptional performance instrument. Experienced turntablists will find the ttm 56 comfortable and familiar. The ttm 56 has many unique features which are mastered quicker if you read the manu...
Page 4
Manual- rear panel hook-up inputs pgm 1 and pgm 2 each have stereo phono and stereo line inputs. Phono 1 and phono 2 inputs are riaa compensated inputs, for turntables only! Phono gnd terminals provide independent ground connect points for turntables. It is very important that each turntable have a ...
Page 5
Manual- outputs aux out may be used for recording, booth monitoring, a second zone, or for connecting to another mixer for session mix. Aux out is the same as the master mix with independent level control. Master out includes two sets of stereo outputs: the ¼" trs jacks provide high current balanced...
Page 6
Manual- mic level high low high gain gain high mid eq eq mid aux out low flexfx flexfx low phones level pgm 2 pgm 1 master ol 10 0 +12 -12 +12 -12 +6 off +6 off +6 off +6 off +6 off +6 off 10 0 6 4 2 8 6 4 2 8 10 0 6 4 2 8 10 0 6 4 2 8 10 0 6 4 2 8 10 0 6 4 2 8 aux in +10 +7 +4 +2 0 -4 -2 -7 -10 -20...
Page 7
Manual- flexfx loop flexfx switches send pgm 1, pgm 2 or both to the stereo effects loop. The effects loop is post-fader and post-crossfader. You get great results when using the program faders or crossfader with reverb or other delay effects. The effects loop provides separate stereo send and retur...
Page 8
Manual- full on off full on off full on off full on off left right left right channel fader response channel fader response showing effect of reverse, mode , mode , and contour controls..
Page 9
Manual- crossfader response showing effect of reverse, mode , mode , and contour controls. Crossfader response.
Page 10
Manual- maintaining magnetic faders there are no electrical contacts to clean! The faders in the ttm 56 are designed with materials highly resistant to corrosion and most chemicals. While the faders will handle millions of operations, they may become dirty over time. Bad things may be spilled or spr...
Page 11
Manual- torsion spring sensors remove ribbon remove #4 screw remove #4 screw mark location before disconnecting ribbon: pgm 1 pgm 2 xfader for more effective cleaning and lubrication, follow the directions outlined below: 1. Required tool: #1 philips screwdriver 2. Disconnect the power. 3. Remove kn...
Page 12
Manual-0 ©rane corporation 00 th ave. W., mukilteo wa -0 usa tel --000 fax -- web www.Rane.Com 106266 rotating or replacing transform (phono/line) switches (model st 2) 1. Required tool: #1 philips screwdriver 2. Disconnect the power. 3. Remove knobs from controls covered by the lexan faceplate. 4. ...