Rane TTM57mkII Owner's Manual

Summary of TTM57mkII

  • Page 1

    Owner’s manual ttm57mkii rane ttm57mkii mixer manual.

  • Page 2: Ttm57Mkii

    Owner’s manual 2 ttm57mkii attention: risque de chocs electrique - ne pas ouvrir risk of electric shock do not open caution to reduce the risk of electrical shock, do not open the unit. No user serviceable parts inside. Refer servicing to qualified service personnel. The symbols shown below are inte...

  • Page 3: Ttm57Mkii

    Owner’s manual 3 ttm57mkii attention: risque de chocs electrique - ne pas ouvrir risk of electric shock do not open caution afin d’éviter tout risque de choc électrique, ne pas ouvrir l’appareil. Aucune pièce ne peut être changée par l’utilisateur. Contactez un sav qualifié pour toute intervention. ...

  • Page 4: Ttm57Mkii

    Owner’s manual 4 ttm57mkii copyright notices ©2015 rane corporation. All rights reserved. Serato dj and scratch live are trademarks of serato. Trademarked in the united states and other countries. This software is based in part on the work of the independent jpeg group, and uses libpng code, copyrig...

  • Page 5: Ttm57Mkii

    Owner’s manual 5 ttm57mkii contents 2 important safety instructions 4 copyright notices 4 check list 6 ttm57mkii overview 7 quick start: software 8 quick start: hardware 9 quick start: operation 10 audio connections 11 two usb ports 12 deck input channels 12 source 12 gain 12 tone controls and kill ...

  • Page 6: Ttm57Mkii

    Owner’s manual 6 ttm57mkii ttm57mkii overview slip int dbl censor slip dbl int censor 10 0 2 4 8 6 10 0 2 4 8 6 10 0 2 4 8 6 10 0 2 4 8 6 10 0 2 4 8 6 10 0 2 4 8 6 10 0 2 4 8 6 10 0 2 4 8 6 10 0 2 4 8 6 main cue high low high low high low high low level session in level mic aux mix flexfx flexfx gai...

  • Page 7: Ttm57Mkii

    Owner’s manual 7 ttm57mkii quick start: software before using your mixer, at least read this short section for the basics. Read the complete manual to get the best investment from your new ttm57mkii. This section will help get you started with one computer. Class compliant audio and midi the usb por...

  • Page 8: Ttm57Mkii

    Owner’s manual 8 ttm57mkii booth phono grounds send return deck 1 deck 2 session 100-240v 50/60 hz 15 watts rane corporation out in aux ph / cd aux ph / cd mic flexfx loop usb main out b a right left mic line ph cd -10 +4 ph cd ! ! Usb cd or turntable out cd or turntable out to main speakers or ampl...

  • Page 9: Ttm57Mkii

    Owner’s manual 9 ttm57mkii quick start: operation calibrating serato dj for control vinyl or cd since serato dj is controlled by an analog signal, there is no guarantee of what state that signal will be in by the time the software gets to interpret it. Therefore, serato dj needs to be able to handle...

  • Page 10: Ttm57Mkii

    Owner’s manual 10 ttm57mkii audio connections analog inputs two phono / cd inputs may each be set for ph or cd using the rear panel buttons, in for a turntable and out for a cd deck. Two more rca aux inputs are provided, one for each input channel. This configuration allows you to connect the aux in...

  • Page 11: Ttm57Mkii

    Owner’s manual 11 ttm57mkii two usb ports there are five stereo record channels and five stereo playback channels. These channels are simultaneously available on two usb ports, allowing two computers to share the device. This allows two djs to play together and supports uninterrupted transitions fro...

  • Page 12: Ttm57Mkii

    Owner’s manual 12 ttm57mkii deck input channels source the source selector for deck 1 selects one of four sources: • a left virtual deck (usb stereo playback pair 1-2) from usb a. • assigns midi controls for the left deck software and deck 1 mixer to usb a. • ph / cd (thru): set to ph or cd on the r...

  • Page 13: Ttm57Mkii

    Owner’s manual 13 ttm57mkii filter the filter sweeps from low-pass to high-pass. Set it to 12 o’clock for a flat “no-filter” response. Moving the filter toward the low position progressively reduces high frequencies. Moving the filter toward the high position progressively reduces low frequencies. T...

  • Page 14: Ttm57Mkii

    Owner’s manual 14 ttm57mkii main and booth the main and booth outputs each have their own level control. The main outputs use balanced xlr connectors and the booth outputs use balanced ¼˝ trs connectors. Since the main, booth and session outputs have the same mix, you can run any of them to your mai...

  • Page 15: Ttm57Mkii

    Owner’s manual 15 ttm57mkii software controls the ttm57mkii mixer has dedicated serato dj software controls. Virtual deck and associated controls are assigned to a or b using the deck 1 and deck 2 source selectors. This allows completely independent software control for each port. Simply, deck 1 has...

  • Page 16: Ttm57Mkii

    Owner’s manual 16 ttm57mkii library encoder and shift button • when in the crates folder, rotate the library encoder to highlight the desired crate and press the encoder to select. • when in the songs folder, rotate the library encoder to highlight the desired song and press the encoder to load it. ...

  • Page 17: Ttm57Mkii

    Owner’s manual 17 ttm57mkii in samples mode, the cues / samples button is green , the two bank buttons are blue and the six sample buttons are lit purple if they have an assigned sample. The six center sample buttons trigger loaded samples from a selected bank. If a bank has a sample assigned to a s...

  • Page 18: Ttm57Mkii

    Owner’s manual 18 ttm57mkii dj changeover the ttm57mkii allows two computers to connect to the mixer simultaneously. This allows two djs to play at the same time and for easy dj set changeover, even if they run different software. Connect both computers to the two usb ports on the ttm57mkii. For eac...

  • Page 19: Ttm57Mkii

    Owner’s manual 19 ttm57mkii class compliant usb ports the usb ports are 100% class compliant, allowing hook-up to any mac osx device without the need for an additional driver. A high-performance asio driver runs most windows daw and dj software. Midi end points are class compliant with both osx and ...

  • Page 20: Ttm57Mkii

    Owner’s manual 20 ttm57mkii deck inputs 1-2 control panel analog input source: the analog input for each channel is set for cd (line level) or phono level (ph) using a switch on the rear of the mixer. The control panel shows the input mode selected on the mixer for each of the four inputs. The mode ...

  • Page 21: Ttm57Mkii

    Owner’s manual 21 ttm57mkii general control panel main out can be set to stereo or mono. The booth and session outputs are always in stereo. Headphone tone slideradjusts the tone going to the headphones using spectral tilt filters. • increasing treble reduces lows by the same amount. • increasing ba...

  • Page 22: Ttm57Mkii

    Owner’s manual 22 ttm57mkii midi mapping when using serato dj software, the mixer is plug-and-play with all required midi mapping done for you. For advanced users or with third-party daws, it is possible to custom midi-map most mixer controls on the ttm57mkii and control the lighting and color of bu...

  • Page 23: Ttm57Mkii

    Owner’s manual 23 ttm57mkii control description control type status midi channel control # dec. Control # hex data comment sdj deck 2 loops loop length adjust encoder cc 6 52 34 3f decr, 41 incr loop on encoder switch note 6 50 32 loop roll roll switch note 6 62 3e modifiers shift moment. Switch not...

  • Page 24: Ttm57Mkii

    Owner’s manual 24 ttm57mkii control description control type status midi channel control # dec. Control # hex data comment sdj deck 1 cues pad 1 cue 1 moment. Switch note 5 20 14 cues mode pad 2 cue 2 moment. Switch note 5 21 15 cues mode pad 3 cue 3 moment. Switch note 5 22 16 cues mode pad 4 cue 4...

  • Page 25: Ttm57Mkii

    Owner’s manual 25 ttm57mkii control description control type status midi channel control # dec. Control # hex data comment sdj library encoder deck 1 library scroll encoder cc 16 0 00 3f decr, 41 incr library scroll fast encoder cc 16 1 01 3f decr, 41 incr shift modifier library backward + expand cr...

  • Page 26: Ttm57Mkii

    Owner’s manual 26 ttm57mkii control description control type status midi channel control # dec. Control # hex data comment mixer deck 1 input mode (ph/cd) slide switch cc 1 40 28 0-7f phono (0-3f), cd (40-7f) read-only input mode (ph/cd) control panel cc 15 49 31 0-7f phono (0-3f), cd (40-7f) read-o...

  • Page 27: Ttm57Mkii

    Owner’s manual 27 ttm57mkii control description control type status midi channel control # dec. Control # hex data comment high eq pot cc 2 23 17 0-7f kill high eq moment. Switch note 2 35 23 midi receive velocity sets backlight mid eq pot cc 2 24 18 0-7f kill mid eq moment. Switch note 2 36 24 midi...

  • Page 28: Ttm57Mkii

    Owner’s manual 28 ttm57mkii control description control type status midi channel control # dec. Control # hex data comment usb aux level pot cc 15 45 2d 0-7f usb aux hp/lp filter pot cc 15 46 2e 0-7f headphone level pot cc 15 47 2f 0-7f usb aux cue note (off) moment. Switch note 15 17 11 foot switch...

  • Page 29: Ttm57Mkii

    Owner’s manual 29 ttm57mkii rgb colors midi note velocity (hex) color # bright on bright blink dim on dim blink 0 20 (led off) 60 (led off) 00 (led off) 40 (led off) 1 21 61 01 41 2 22 62 02 42 3 23 63 03 43 4 24 64 04 44 5 25 65 05 45 6 26 66 06 46 7 27 67 07 47 8 28 68 08 48 9 29 69 09 49 10 2a 6a...

  • Page 30: Ttm57Mkii

    Owner’s manual 30 ttm57mkii magnetic fader maintenance the faders and crossfader in the ttm57mkii are designed with materials highly resistant to corrosion and most chemicals. While they will handle millions of operations, they may become dirty over time. Bad things may be spilled into a fader, but ...

  • Page 31: Ttm57Mkii

    Owner’s manual 31 ttm57mkii sensors fader calibration after cleaning or replacement, the sensors may get moved, affecting the contour. After any fader service, perform this procedure to re-calibrate the faders and crossfader. 1. Power off the ttm57mkii. 2. Move all faders to the center-most position...

  • Page 32: Ttm57Mkii

    Owner’s manual 32 ttm57mkii technical specifications all specifications typical unless otherwise stated analog inputs 4 stereo unbalanced rca jacks …...Phono or line level input rear panel switches for each input …...Phono response riaa ±1 db, gain: 31 db at 1 khz …........Rumble filter butterworth ...

  • Page 33: Ttm57Mkii

    Owner’s manual 33 ttm57mkii limited warranties factory authorized service your unit may someday need to be serviced by the rane factory if you live in the usa. International customers should contact your dealer or distributor for service. You must call the rane factory before shipping. Please do not...

  • Page 34: Ttm57Mkii

    Owner’s manual 34 ttm57mkii warranty procedure - valid in u.S.A. Only notice! You must complete and return the warranty card or register your product online to extend the warranty from 2 years to 3 years! To validate your extended warranty: use the postcard that came in the box with your unit, or go...

  • Page 35: Ttm57Mkii

    Owner’s manual 35 ttm57mkii declaration of conformity application of council directives: 2001/95/ec 2002/96/ec 2004/108/ec 2006/95/ec 2011/65/eu manufacturer: rane corporation 10802 47th avenue west mukilteo wa 98275-5000 usa this equipment has been tested and found to be in compliance with all appl...

  • Page 36: Ttm57Mkii

    Owner’s manual 36 ttm57mkii part 22122.