Range Master ER-8102P-3 User Manual - page 12
AFTER SALES SUPPORT
ITEM #
45090-14
email: rangemaster@1800acs.com
888-892-2075
12
Thisgrillisdesignedtooperatewitha1lb.7.75in.or10.6in.highdisposable/16.4oz.or14.1oz.propanegastank
(DOT39Cylinder)(Figure1).DONOTATTEMPTTOREFILLANY1lb.(16.4oz.or14.1oz.)PROPANEGASTANKS!
1. CONNECTINGLPGASTANK
Only cylinders marked “propane” may be used.
Note: 1 lb cylinders may form frost when near empty.
1. Make sure the regulator/control knob is in the “OFF ” position.
2. Lubricate the threads of the regulator/control knob with petroleum jelly.
Line up threads on LP gas tank with regulator/control knob.
3.InsertandrotateLPgastankclockwiseuntiltheyfitsnuglytogether.(Figure1)
HANDTIGHTENONLY.Becarefulnottocrossthreadwhenscrewingintank.
4. Perform leak test per “Checking for Leaks” section.
2. DISCONNECTINGLPGASTANK
1. Turn the regulator/control knob to the “OFF ” position.
2. Rotate LP gas tank counterclockwise until it is detached (Figure 2).
3. CHECKINGFORLEAKS
BURNER CONNECTIONS
Make sure the control valve is securely fastened to the burner.
If your unit was assembled for you, visually check the connection between the burner pipe and control valve.
Make sure the burner pipe fits over the control valve.
Make2-3oz.ofleaksolutionbymixingonepartliquiddishwashingsoapwiththreepartswater.
Make sure control knob is off.
Spoon several drops of solution, or use squirt bottle, at the burner connection.
Turn gas control on.
Inspect the solution at the connection, looking for bubbles. If NO bubbles appear, the connections are secure.
If bubbles appear, you have a leak.
Loosen and retighten this connection, making sure the connection is secure.
WARNING:FAILURETOINSPECTTHISCONNECTIONORFOLLOWTHESE
INSTRUCTIONS COULD CAUSE A FIRE OR AN EXPLOSION
WHICHCANCAUSEDEATH,SERIOUSBODILYINJURYORDAMAGETOPROPERTY.
Figure 1
Figure 2
OPERATING INSTRUCTIONS