Range Master Professional+ 100 FX Dual Fuel User's Manual & Installation Instructions - page 26
INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
22
ArtNo.070-0014 - Stability bracket - Wall fitting
Cooker
Stability bracket
Floor
3 mm min
Typical floor mounting
Stability chain
ArtNo.010-0004 Moving the cooker
Fig.7-4
Fig.7-5
Lowering the Two Rear Rollers
To adjust the height of the rear of the cooker, first fit a 13 mm
spanner or socket wrench onto the hexagonal adjusting
nut (Fig.7-4). Rotate the nut – clockwise to raise – counter-
clockwise to lower.
Make 10 complete (360°) turns clockwise.
Make sure you lower BOTH REAR ROLLERS.
Completing the Move
Unfold the rear edge of the pack base tray.
We recommend that you remove the oven doors to move
the cooker. Open the oven door fully and place the supplied
holding pins in the drop down hinges (Fig.7-5).
Carefully lift the door panel up and out, place safely to one
side. You can now get a good grip from inside of the oven
(not the fascia panel) as you move the oven (Fig.7-6).
Carefully push the cooker backwards off the cardboard base.
Remove the pack base tray.
Position the cooker close to its final position, leaving just
enough space to get behind it.
After moving, carefully refit the door panel and push down
gently to release the holding pins.
n
n
Do not use the door handles or control knobs to
manoeuvre the cooker.
Fitting the Stability Bracket or Chain
Unless otherwise stated, a cooker using a flexible gas
connector must be secured with a suitable stability device.
Suitable stability devices are shown in Fig.7-7, Fig.7-8 and
Fig.7-9.
If you are using a stability chain (Fig.7-7) then the chain
should be kept as short as is practicable and fixed firmly to
the rear of the cooker.
If you are using a stability bracket (Fig.7-8 and Fig.7-9), then
adjust the bracket to give the smallest practicable clearance
between the bracket and the engagement slot in the rear of
the cooker.
Fit the bracket so that it engages as far as possible over the
chassis of the cooker.
Fig.7-7
Fig.7-8
Fig.7-6