61000 series 48” versions broan-nutone llc. 926 west state street, hartford, wi 53027 nutone, inc., 4820 red bank road, cincinnati, oh 45227 broan-nutone canada, inc.1140 tristar drive, mississauga, ontario, l5t 1h9 english......................................2 franÇais................................
- 2 - read and save these instructions warning to reduce the risk of fire, electric shock, or injury to persons, observe the following: 1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the w...
- 3 - ! Caution 1. To reduce risk of fire and to properly exhaust air, be sure to duct air outside. Do not vent exhaust air into spaces within walls or ceilings or into attics, crawl spaces, or garages. 2. Take care when using cleaning agents or detergents. 3. Avoid using food products that produce ...
- 4 - prepare the hood unpack hood and check contents. You should receive: 1 - hood 1 - decorative flue assembly 1 - flue mounting bracket 1 - parts bag (b08081196) containing: 2 - mounting brackets 10 - mounting screws (4,8 x 38mm pan head) 4 - mounting screws (3,9 x 9,5mm pan head) 4 - mounting sc...
- 5 - install the ductwork note: to reduce the risk of fire, use only metal ductwork. 1. Decide where the ductwork will run between the hood and the outside. 2. A straight, short duct run will allow the hood to perform most efficiently. 3. Long duct runs, elbows, and transitions will reduce the perf...
- 6 - depth adjustment screws install the hood 1. Hang the hood from the brackets through the rectangular cut-outs on the back of the hood. Cut-outs are larger than the brackets to allow for horizontal adjustment. The bottom of the hood should be 24" to 30" above the cooking surface. 2. Height adjus...
- 7 - wiring note: this range hood must be properly grounded. The unit should be installed by a qualified electrician in accordance with all applicable national and local electrical codes. Grounding instructions this appliance must be grounded. In the event of an electrical short circuit, grounding ...
- 8 - fasten flue to hood and bracket with mounting screws (3,9x9,5mm) 8" round metal duct decorative flue duct tape flue mounting bracket connect ductwork 1. Use (2) screws (4,8x38mm) and drywall anchors to secure flue mounting bracket to the ceiling or wall as shown. 2. Use 8" round metal duct to ...
- 9 - maintenance proper maintenance of the range hood will assure proper performance of the unit. Grease filters the grease filters should be cleaned fre- quently. Use a warm detergent solution. Grease filters are dishwasher safe. Remove filter by pushing filter towards the back of hood and rotatin...
- 10 - operation controls the hood is operated using the slide controls under the front edge of the hood. The light switch turns the halogen lights on and off. The blower on / off switch turns the blower on to the running speed set by the blower speed control. The blower must be turned on and off us...
- 11 - fuse replacement switch off the electricity supply. Remove the grease filters. Remove the electrical box support and open the fuse box. Replace with the same type of fuse (5x20mm, 4a, 125v). Electrical box support fuse fuse box broan-nutone llc one year limited warranty broan-nutone llc warra...
- 32 - service parts model 61000 (48” versions) - parts for stainless steel models shown. For service parts for black, white, polished brass, or brushed copper models, call broan customer service. Key no. Part no. Description 9 b08087136 grease filter (n. 4) 14 b02300233 motor capacitor 16 be3345326...
- 35 - service parts - liste pieces de rechange - lista de piezas de recambio model 61000 (48” versions).
