Rangemaster 90 Dual Fuel User's Manual & Installation Instructions - 7. Installation
INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
17
Dear Installer
Before you start your installation, please complete the details
below, so that, if your customer has a problem relating to
your installation, they will be able to contact you easily.
Safety Requirements and Regulations
You must be aware of the following safety requirements &
regulations.
n
n
Before installation, make sure that the local
distribution conditions (nature of the gas and gas
pressure) and the adjustment of the appliance are
compatible.
n
n
This cooker is a Class 2 Subclass 1 appliance.
n
n
This appliance can be converted for use on another
gas.
n
n
The appliance must be installed in accordance with
the regulations in force and only in a well-ventilated
space.
n
n
Read the instructions before installing or using this
appliance.
n
n
Failure to install the appliance correctly could
invalidate any warranty or liability claims and lead
to prosecution.
Provision of Ventilation
This appliance is not connected to a combustion products
evacuation device. Particular attention shall be given to the
relevant requirements regarding ventilation.
Location of Cooker
The cooker may be installed in a kitchen/kitchen diner but
NOT in a room containing a bath or shower.
This appliance is designed for domestic cooking only. Use
for any other purpose could invalidate any warranty or
liability claim.
Note: An appliance for use on LPG must not be installed
in a room or internal space below ground level, e.g. in a
basement.
Conversion
This appliance is supplied set for G20 20 mbar Cat II2H3+.
A conversion kit for another gas is included with the cooker.
If the appliance is to be converted to another gas we
recommend that this is carried out before installation. See the
instructions that are supplied with the conversion kit.
After converting the appliance, please attach the Gas
Conversion sticker over the appropriate area of the data
badge – this will identify the gas type for which the appliance
is now set.
ArtNo.050-0011 - Installer information table
Installer’s Name
Appliance Serial Number
Installer’s Telephone Number
Installer’s Company