Rangemaster Elan 110 Ceramic User Manual - page 35
SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
35
15. To Change Oven Door Outer Panel
Remove the two plastic blanking plugs from the door
handles. Remove the 4mm Hex headed screws holding
the handle to the door with the hexagon key tool.
Remove two screws from top edge and two from
bottom edge of the door.
Remove outer door panel. Fit door handle to new
panel. Fit the plastic blanking plugs to the fixing holes.
The handles should be above the fixings.
Fit panel to door. If replacing the outer panel on the
right hand door (with the Thermodial) take care to
make sure the sensor of the Thermodial is sealed to
the door by the rubber grommet.
Reassemble in reverse order.
16. To Change Oven Door Catch
Remove outer door panel (see 15). Remove screws ‘B’
holding catch assembly to inner door panel. Fit new
catch and reassemble in reverse order.
Check correct door operation.
17. To Change Oven Door Seal
Open oven door. The seal is held in place by small
hooks on the rear face. At the corner pull seal
diagonally away from the door centre until that hook is
released. Proceed to the next hook and release it in a
similar way, and so on.
Fig. 4
When fitting new seal, position the seal join at the
bottom. Hook the new seal in one of the corner holes
of the door, and proceed round the door snapping in
each hook in turn.
18. To Adjust Oven Door Catch Keep
Open oven door, slacken off locknut at base of keep,
and screw in or out as required until required fit is
obtained. Retighten locking nut.
19. To Change Ignition Generator
Disconnect from electricity supply.
Pull cooker forward to gain access to the cover box at
the rear of the left hand cooker. Remove the screws
securing the cover and lift clear. Pull off all the leads to
the generator noting their positions. Slacken the two
screws holding generator to cooker and remove
generator.
Fit new generator to cooker and replace leads.
Reassemble in reverse order. Refer to wiring diagram.
Check ignition performance.