- DL manuals
- Rangemaster
- Refrigerator
- RBC38
- Installation, operation and maintenance instructions
Rangemaster RBC38 Installation, operation and maintenance instructions
Summary of RBC38
Page 1
Installation operation and maintenance instructions refrigerated beverage centre with microsentry™ refrigeration monitor rbc38 rbc60 rangemaster refrigerated beverage centre.
Page 2
1 table of contents unpacking your refrigerator............................................ Removing the packaging............................................. Warranty registration .................................................. Installing your refrigerator..........................................
Page 3
Unpacking your beverage centre 2 remove packaging your refrigerator has been packed for shipment with all parts that could be damaged by movement securely fas- tened. Cut the banding material at the bottom of the carton, unfold the carton at the bottom and remove the carton from the appliance. Remov...
Page 4
Installing your beverage centre select location the proper location will ensure peak performance of your appliance. We recommend a location where the unit will be out of direct sunlight and away from heat sources. To assure your product performs to specifications the recom- mended installation locat...
Page 5
Electrical connection 4 do not use an extension cord with this appliance. Figure 2 green/yellow (earth) fuse (13a) blue (neutral) brown (live) 13a must be used and fitted with a 13a fuse “asta” ap- proved to bs 1363. If you replace the fuse, the cover must be refitted. If the cover is lost, the plug...
Page 6
Using your microsentry™ refrigeration monitor during initial startup, or anytime power is interrupted, there will be an approximate 5 minute delay before the refrigerator starts. During this period the controller will be assessing the temperature in the refrigerator and the display will appear errat...
Page 7
6 note using your microsentry™ refrigeration monitor 1) press and release the “set button four times. “cnd” will be displayed on the screen. 2) while “cnd” is displayed, press and hold the “set” but- ton. The display will show the number of weeks the refrigerator has been running. 3) while holding t...
Page 8
Dimensions for rbc38 glass door 7 857 to 883mm rough in opening dimensions, for rbc38 glass door 381mm *610mm * depth dimension may vary depending on each individual installation. 876mm electrical requirements: 230 volts, 1.7 amps running max. A three pin earthed receptacle is required. Power outlet...
Page 9
Dimensions for rbc60 glass door rough in opening dimensions for rbc60 glass door 610mm * 610mm * depth dimension may vary depending on each individual installation. 876mm electrical requirements: 230 volts, 1.7 amps run- ning max. A three pin earthed receptacle is re- quired. Power outlet can be loc...
Page 10
Rbc38 beverage centre features 9 insert wine bottles the wine rack pull-out shelf holds four (4) bottles. See fig- ure 4 for typical wine bottle orientation. Loading tips and suggestions the wine rack can be located at any shelf support but it is recommended it be located toward the uppermost positi...
Page 11
Rbc60 beverage centre features 10 figure 7 stationary shelf perforated metal shelf glass shelf wine shelf wine cradle tall bottle storage loading tips and suggestions the wine rack pull-out shelf holds eight (8) bottles. See figure 6 and figure 8 for typical wine bottle orientation. The wine rack is...
Page 12
Energy saving tips 11 the following suggestions will minimize the cost of oper- ating your refrigeration appliance. 1. Do not install your appliance next to a hot appliance, (cooker, dishwasher, etc.). Heating air duct, or other heat sources. 2. Install product out of direct sunlight. 3. Assure the ...
Page 13
12 care and cleaning of your beverage centre condenser the condenser underneath the cabinet does not require frequent cleaning; however, satisfactory cooling depends on adequate ventilation over this heat exchanger. It is recom- mended to annually clean the condenser by vacuuming and brushing. To ac...
Page 14
Care and cleaning of your beverage centre door alignment the door should be parallel to the sides and top of the refrigerator. If alignment is necessary the door may be adjusted by loosening the 2 screws which secure the hinge adapter brackets to the door and adjusting the door side to side. Use a 5...
Page 15
14 troubleshooting your beverage centre problem possible cause remedy unit not cold enough. • control set too warm. • airflow to front grille blocked. • excessive usage or prolonged. Door openings. • door gasket not sealing properly. • adjust temperature colder. (see “set temperatures” on page 5). A...
Page 16
How to obtain service if you do need service if you do need service, contact your dealer or rangemas- ter. In any correspondence, refer to the model number and serial number of your unit which is located on the upper left hand side of the wall liner. Retain your proof of purchase. Please complete th...
Page 17
16 guarantee free 1st year parts & labour guarantee covers goods for the period of 12 months from the date of purchase subject of the below exclusions. Terms and conditions the appliance - • has been correctly installed in accordance with current legislation, relevant british standards, and codes of...
Page 18
17 appendix a, additional microsentry™ features information menu: the following features are available on the information menu. • currenttemperature • maximumstoredtemperature • minimumstoredtemperature • totaloperatingtimeofthecondenser • keypadlockout to access the information menu press “set” but...
Page 19
Notes.
Page 20
All specifications and product designs subject to change without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions, replacements or compensation for previously purchased products. 41011822 rev d 6/3/13 www.Rangemaster.Co.Uk clarence street, royal leami...