Rangemaster RDW1045FI User Manual & Installation & Service Instructions - page 14
12
Tablet button
Tablet indicator
Fig.2-19
Modifying a Program
n
n
CAUTION!
There is a risk of water coming out from inside the
dishwasher. DO NOT open the door fully until the
spray arm has stopped rotating.
A cycle that is underway can be modified if it has only been
running for a short time. Otherwise, the detergent may have
already been used and the dishwasher may have already
drained the wash water. If this is the case, the detergent
dispenser must be refilled (see ‘Loading the detergent’).
To modify a cycle that is already underway, open the door
and select a new program by pressing the program selection
button. Closing the door will start the new program from a
suitable point in the old program.
Using 3-in-1 Detergent Tablets
General Advice
1.
Before using these products you should first check
that the water hardness in your supply is compatible
with their use, as per the detergent manufacturers
instructions (on the product packaging).
2.
These products should be strictly used according to the
detergent manufacturers instructions.
3.
If you encounter problems when using 3-in-1 products
for the first time then please contact the detergent
manufacturers care line (the telephone number is given
on the product packaging).
Special Advice
When using combination products, there is no need to add
additional salt or rinse aid as these are not required. Indicator
lights for salt and rinse aid can be ignored. It may be helpful
to select the lowest possible setting for water hardness.
To Select the ‘Tablet’ Function:
1.
Open the door.
2.
Select the program and then press the ‘tablet’ button
(Fig.2-19). The tablet indicator will light.
3.
Close the door. The dishwasher will start immediately.
To Cancel the ‘Tablet’ Function:
Follow the ‘Cancelling a Program’ instructions.
If you decide to switch to the use of a standard detergent
system we advise that you:
1.
Refill both the salt and rinse aid compartments.
2.
Switch the water hardness setting to the highest
possible position and run for three normal cycles
without a load.
3.
Readjust the water hardness setting again according
to the conditions for your region. For more information
please refer to your instruction manual.