1. DL manuals
  2. Rangemaster
  3. Ventilation Hood
  4. RM51000 Series
  5. User Instructions

Rangemaster RM51000 Series User Instructions

Other manuals for RM51000 Series: Instructions Manual

Summary of RM51000 Series

  • Page 1

    Rm51000 rm52000 series broan-nutone llc. 926 west state street, hartford, wi 53027 nutone, inc., 4820 red bank road, cincinnati, oh 45227 broan-nutone canada, inc.1140 tristar drive, mississauga, ontario, l5t 1h9 english......................................3 franÇais...................................

  • Page 3: Warning

    - 3 - read and save these instructions warning suitable for use in household cooking area. To reduce the risk of fire, electrical shock, or injury to persons, observe the following: 1. Use this unit only in the manner intended by the manufacturer. If you have questions, con- tact the manufacturer at...

  • Page 4: Prepare The Hood

    - 4 - prepare the hood unpack hood and check contents. You should receive: 1 - hood 1 - decorative flue assembly 1 - parts bag containing: 1 - mounting bracket 1 - discharge collar 1 - flue mounting bracket 8 - mounting screws (4,8 x 38mm pan head) 5 - mounting screws (3,9 x 9,5mm pan head) 8 - dryw...

  • Page 5: Install Mounting

    - 5 - install mounting bracket 1. Construct wood wall framing that is flush with interior surface of wall studs. Make sure: a) the framing is centered over installation location. B) the height of the framing will allow the mounting bracket to be secured to the framing within the dimensions shown. 2....

  • Page 6: Mount The Plate

    - 6 - mount the plate mount the plate of the electrical system attaching it with 3 screws. Plate of the electrical system wiring note: this range hood must be properly grounded. The unit should be installed by a qualified electrician in accordance with all applicable national and local electrical co...

  • Page 7: Connect Ductwork

    - 7 - flue mounting bracket mounting screws = = connect ductwork ducted configuration 1. Adjust the width of the flue mounting bracket to equal the inside width of decorative flue. Insert and tighten mounting screws to hold bracket width. 2. Use mounting screws and wall anchors to secure flue mounti...

  • Page 8

    - 8 - upper flue section non-ducted recirculation plenum air vents (in upper flue section) upper bracket lower flue section duct seam discharge collar 5" round metal duct reduction measure ! ! Non-ducted recirculation configuration 1. Adjust the width of the flue mounting bracket to equal the inside...

  • Page 9: Non-Ducted

    - 9 - non-ducted recirculation filter installation 1. Purchase a charcoal filter (b03300488) from your dealer. 2. Install the filter by pressing the 2 tabs on the filter down into the special housing and rotating upward. Charcoal filter grease filters maintenance proper maintenance of the range hood...

  • Page 10: Operation

    - 10 - operation controls the hood is operated using the slide controls under the bottom of the hood. The light switch turns the lamps on and off. The blower switch :makes it possible to select the motor operating speed. Position 0: motor off. The pilot lamp lights up whenever the blower is on. Ligh...

  • Page 11: Warranty

    - 11 - broan-nutone llc one year limited warranty broan-nutone llc warrants to the original consumer purchaser of its products that such products will be free from defects in materials or workmanship for a period of one year from the date of original purchase. There are no other war- ranties, expres...