Rm61000ex series broan-nutone llc. 926 west state street, hartford, wi 53027 nutone, inc., 4820 red bank road, cincinnati, oh 45227 broan-nutone canada, inc.1140 tristar drive, mississauga, ontario, l5t 1h9 english.....................................2 franÇais................................13 espa...
- 2 - read and save these instructions warning to reduce the risk of fire, electric shock, or injury to persons, observe the following: 1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the w...
- 3 - ! Caution 1. To reduce risk of fire and to properly exhaust air, be sure to duct air outside. Do not vent exhaust air into spaces within walls or ceilings or into attics, crawl spaces, or garages. 2. Take care when using cleaning agents or detergents. 3. Avoid using food products that produce ...
- 4 - prepare the hood unpack hood and check contents. You should receive: 1 - hood 1 - decorative flue assembly 1 - flue mounting bracket 1 - parts bag (b08081196) containing: 2 - mounting brackets 8 - mounting screws (4,8 x 38mm pan head) 4 - mounting screws (3,9 x 9,5mm pan head) 4 - mounting scr...
- 5 - exterior or in-line blower selection caution: either an exterior blower or in-line blower may be used with this hood. The rm61000ex hood must be installed with blower models 331h, 332h, 335, 336, hlb3, hlb6, hlb9 or hlb11 only. Other blowers cannot be substituted (blowers sold separately). The...
- 6 - install mounting brackets 1. Construct wood wall framing that is flush with interior surface of wall studs.Make sure: a) the framing is centered over installation location. B) the height of the framing will allow the mounting brackets to be secured to the framing within the dimensions shown. 2...
- 7 - depth adjustment screws wiring note: this range hood must be properly grounded. The unit should be installed by a qualified electrician in accordance with all applicable national and local electrical codes. Grounding instructions this appliance must be grounded. In the event of an electrical s...
- 8 - fasten flue to hood and bracket with mounting screws (3,9x9,5mm) 8" round metal duct decorative flue duct tape flue mounting bracket connect ductwork 1. Use mounting screws (4,8x38mm) and drywall anchors to secure flue mounting bracket to the ceiling and wall as shown. 2. Use 8" round metal du...
- 9 - maintenance proper maintenance of the range hood will assure proper performance of the unit. Grease filters the grease filters should be cleaned fre- quently. Use a warm detergent solution. Grease filters are dishwasher safe. Remove filter by pushing filter towards the back of hood and rotatin...
- 10 - operation controls the hood is operated using the slide controls under the front edge of the hood. The light switch turns the halogen lights on and off. The blower on / off switch turns the blower on to the running speed set by the blower speed control. The blower must be turned on and off us...
- 11 - fuse replacement switch off the electricity supply. Remove the grease filters. Remove the electrical box support and open the electrical box. Replace with the same type of fuse (5x20mm, 5a, 125v). Electrical box support fuse electrical box.
- 12 - broan-nutone llc one year limited warranty broan-nutone llc warrants to the original consumer purchaser of its products that such products will be free from defects in materials or workmanship for a period of one year from the date of original purchase. There are no other war- ranties, expres...
- 36 - service parts model rm61000ex - parts for stainless steel models shown. For service parts for black, white, polished brass, or brushed copper models, call broan customer service. Key no. Part no. Description 9 b08087135 grease filter (n.3) - 36” model 9 b08087136 grease filter (n. 4) - 48” mo...
- 39 - service parts - liste pieces de rechange - lista de piezas de recambio model 61000 ex.
