Rangemaster RMG1H60SG Instruction Manual

Manual is about: Rangemaster Extractor Hood Instructions Manual

Summary of RMG1H60SG

  • Page 1

    Rmg1h60sg rmg1h90sg instructions manual www.Rangemaster.Co.Uk.

  • Page 2: Instructions Manual

    En 2 2 instructions manual index recommendations and suggestions ......................................................................................................................3 characteristics.......................................................................................................

  • Page 3

    En 3 3 recommendations and suggestions the instructions for use apply to several versions of this appliance. Accord- ingly, you may find descriptions of individual features that do not apply to your specific appliance. Installation • the manufacturer will not be held liable for any damages resulting...

  • Page 4: Characteristics

    En 4 4 characteristics dimensions.

  • Page 5

    En 5 5 components ref. Q.Ty product components 1 1 hood body, complete with: controls, light, blower, filters 2 1 telescopic chimney comprising: 2.1 1 upper section 2.2 1 lower section 9 1 reducer flange ø 150-120 mm 10 1 adapting ring ø 120-125 mm 14.1 2 air outlet connection extension 15 1 air out...

  • Page 6: Installation

    En 6 6 installation wall drilling and bracket fixing 7.2.1 11 12a x 116 1÷2 116 1040 450 mm min wall marking: • draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre of the area in which the hood will be installed. • draw a horizontal line at 1040 mm a...

  • Page 7

    En 7 7 mounting the hood body • before attaching the hood body, tighten the two screws vr lo- cated on the hood body mounting points. • hook the hood body onto the screws 12a. • fully tighten support screws 12a. • adjust screws vr to level the hood body. 12a vr connections ducted version air exhaust...

  • Page 8

    En 8 8 electrical connection • connect the hood to the mains through a two-pole switch hav- ing a contact gap of at least 3 mm. • remove the grease filters (see paragraph maintenance) being sure that the connector of the feeding cable is correctly inserted in the socket placed on the side of the fan...

  • Page 9: Use

    En 9 9 use b a d c e g f i h l control board key function display a switches the extractor motor on and off at the latest selected speed indicates the selected speed. B decreases the suction speed. The number of lit leds decreases. C increases the suction speed. The number of lit leds increases. D b...

  • Page 10: Maintenance

    En 1 0 10 maintenance remote control (optional) the appliance can be controlled using a remote control powered by a 1.5 v carbon-zinc alkaline batteries of the standard lr03- aaa type. • do not place the remote control near to heat sources. • used batteries must be disposed of in the proper manner. ...

  • Page 11

    En 1 1 11 metal grease filters metal filters can be washed also in a dish machine. They need to be washed every time a drop-symbol ap- pears in the display or at least every two months. In ca- se of very frequent use these have to be washed even more often. Alarm reset • press the g-key for at least...

  • Page 12

    En 1 2 12 charcoal filter (recycling version) this filter cannot be washed or regenerated. It must be replaced when the c appears on the display or at least once every 4 months. The filter saturation alarm has to be activated already before. Activation of the alarm signal • in the recycling version ...

  • Page 16

    436004190_ver1 aga rangemaster ltd..