Rmg2h60ss rmg2h90ss instructions manual www.Rangemaster.Co.Uk.
En 2 2 instructions manual index recommendations and suggestions ......................................................................................................................3 characteristics.......................................................................................................
En 3 3 recommendations and suggestions the instructions for use apply to several versions of this appliance. Accord- ingly, you may find descriptions of individual features that do not apply to your specific appliance. Installation • the manufacturer will not be held liable for any damages resulting...
En 4 4 characteristics dimensions.
En 5 5 components ref. Q.Ty product components 1 1 hood body, complete with: controls, light, blower, filters 2 1 telescopic chimney comprising: 2.1 1 upper section 2.2 1 lower section 9 1 reducer flange ø 150-120 mm 10 1 adapting ring ø 120-125 mm 14.1 2 air outlet connection extension 15 1 air out...
En 6 6 installation wall drilling and bracket fixing 7.2.1 11 12a x 116 1÷2 116 1040 450 mm min wall marking: • draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre of the area in which the hood will be installed. • draw a horizontal line at 1040 mm a...
En 7 7 mounting the hood body • before attaching the hood body, tighten the two screws vr lo- cated on the hood body mounting points. • hook the hood body onto the screws 12a. • fully tighten support screws 12a. • adjust screws vr to level the hood body. 12a vr connections ducted version air exhaust...
En 8 8 electrical connection • connect the hood to the mains through a two-pole switch hav- ing a contact gap of at least 3 mm. • remove the grease filters (see paragraph maintenance) being sure that the connector of the feeding cable is correctly inserted in the socket placed on the side of the fan...
En 9 9 use l s1 t1 t2 t3 t4 control panel the hood can be switched on pushing directly onto the requested speed without firstly having to select 0/1 button. Key led functions l 0/1 light turns lighting on and off. T1 0/1 motoron first speed. When pressed for about 1 seconds the motor is switched off...
En 1 0 10 maintenance remote control (optional) the appliance can be controlled using a remote control powered by a 1.5 v carbon-zinc alkaline batteries of the standard lr03- aaa type. • do not place the remote control near to heat sources. • used batteries must be disposed of in the proper manner. ...
En 1 1 11 grease filters cleaning metal self- supporting grease fil- ters alarm signal reset • switch off the lights and extractor motor. • press button t3 for at least 3 seconds, until the leds start to flash. Cleaning the filters • the filters are washable and must be cleaned at least every 2 mont...
En 1 2 12 activated charcoal filter (recirculation version) the filter is not washable and cannot be regenerated. It must be replaced when led s1 flashes or at least every 4 months. The alarm signal will only light up when the extractor motor is swi- tched on. Alarm signal activation • in recirculat...
436004188_ver1 aga rangemaster ltd..