Rangemaster Toledo 110 Ceramic User Manual - page 7
7
GB/IE
2 Minute Tour continues over the page...
T
HE
O
VENS
More about the ovens on page 10
During use the appliance becomes hot. Care should be taken to avoid the touching heating
elements inside the oven.
3
When cooking foods with high
water content (e.g. oven chips)
there may be some steam
visible at the grille at the rear of the
hotplate. This is perfectly normal.
The oven indicator light will
glow until the oven has
reached the temperature you
selected. It will then cycle on and off
during cooking.
2
Turn the oven knob to the
temperature you need.
A cooling fan will start to run as
soon as an oven is turned on. The
fan will continue to run while the
oven (or grill) is on and for about
10min after it is turned off. At low
oven settings the fan may cycle on
and off. Never turn off the power
supply to the cooker before the
cooling fan stops.
1
4
The fan only setting. The fan
circulates air inside the oven but
the heating element is not
turned on. This setting is useful for
defrosting frozen foods.
Whole chickens and large joints of
meat should be defrosted in the
refrigerator. Do not defrost in a warm
oven or whilst the adjoining oven is
hot.
6
5
The fan in the right hand oven
circulates hot air continuously
which means faster more even
cooking.
The recommended cooking
temperatures for a fanned oven are
generally lower than a non-fanned
oven.
T
HE
L
EFT
HAND
O
VEN
T
HE
R
IGHT
HAND
F
AN
O
VEN
The left hand conventional oven
is fitted with two heating
elements, one visible in the top
of the oven and the second under the
oven base.
Be careful to avoid touching the top
element and element deflector when
placing or removing items from the
oven.
7
You can use the timer to turn
the oven on and off. Check
clock is set to time of day.
The clock must be set to the time of
day before the ovens will work.
To set the time of day
More about the clock on page 12
Press and hold as shown. At the same time,
press (-) or (+) until the correct time shows.
Don’t forget it’s a 24 hour clock. If you make
a mistake or press the wrong button, turn
off the power supply for a minute or two and
start again.