Rangemaster Toledo 90 Ceramic Electric User Manual - page 16
16
Each side of the oven
is fi xed with four fi xing
screws. You don’t have
to remove the screws
to remove the oven
linings. Lift each side
panel upwards and
they will slide off the
screws. Then pull them
forwards.
Once the linings are removed, the oven enamel
interior can be cleaned.
When replacing the linings fi t the side linings
fi rst.
Make sure you fi t the oven roof with the slot at
the front.
The Tall Oven
To clean the oven
sides slide out the
shelves, unhook the
supports from the oven
sides and lift out.
Moving your cooker
Switch off the electricity supply.
The cooker is heavy, two people may
be required to move it. There are two
levelling rollers at the back and also two
screw down levelling feet at the front.
Open the grill door and right hand oven door so
that you can get a good grip on the bottom of
the fascia panel as you move the oven.
Lift the front of the cooker slightly and pull
forward.
Do not move the oven by pulling the
door handles or knobs.
Move the oven a bit at a time, checking behind
it to make sure the electricity supply cable is not
caught. Make sure the cable has suffi cient slack
to move the cooker forward as you go along.
If a stability chain is fi tted, release it as
you ease the cooker out. Don’t forget to
refi t it when you replace the cooker.
When you replace the cooker, again check
behind to make sure that the electricity cable is
not caught or trapped.