Rangemaster Toledo FS Installation And User Manual - page 15
INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
11
468 mm
1150 mm
600 mm
minimum
Worktop
Cut-out
410mm min
1100mm* min
Oven front
top supports
the hotplate
Ovens
Wall
Bracket at rear
fixed to wall
Hob
Worktop
75 mm
min
650 mm minimum
Fig.5-1
Fig.5-3
Positioning the Hob
Fit the hob into a worksurface which is at least 600 mm deep.
You can fit the hob to worktops of between 30 mm and
50 mm thick.
For example: If fitting to a 30 mm worktop, the base of the
hob extends below the worktop by up to 20 mm. Make sure
that there is sufficient clearance below the hob to avoid
interference with drawer bodies, support struts, etc.
The cut-out should be positioned centrally so that the spaces
at the front and rear are equal. Fig.5-1 shows the required
cut-out.
Fig.5-2 shows the minimum recommended distances from
the hob to nearby surfaces. Above hotplate level a gap of
75 mm should be left between the left-hand side of the
hotplate and any adjacent vertical surface.
For non-combustible surfaces (such as unpainted metal or
ceramic tiles) this can be reduced to 25 mm.
A minimum space of 650 mm is required between the top of
the hotplate and a horizontal combustible surface.
*Any cookerhood should be installed in accordance with the
hood manufacturer’s instructions.
**Any splashback must be fitted in accordance with the
manufacturers instructions. Allowance should be made for the
additional height of the flue trim, which is fitted to the cooker
hob.
Surfaces of furniture and walls at the sides and rear of the
hotplate should be heat, splash and steam resistant. Certain
types of vinyl or laminate kitchen furniture are particularly
prone to heat damage and discolouration. We cannot accept
responsibility for damage caused by normal use of the
hotplate to any material that de-laminates or discolours at
temperatures less than 65 °C above room temperature.
n
n
For safety reasons curtains MUST NOT be fitted
immediately behind the hotplate.
Note: When the Toledo FS ovens are situated under the hob,
additional brackets should be fixed to the rear wall to support
the rear edge of the worktop. Two right-angle brackets are
supplied for this purpose. Alternatively, a wooden baton
could be fixed to the wall under the rear edge.
The front edge will be supported by the ovens once they are
in place. It is important that the hob is placed directly above
the ovens to ensure this (Fig.5-4).
Moving the Hob
n
n
The hob is heavy. Take great care.
We recommend two people move the hob.
Conversion to LP Gas
If the appliance is to be converted to LP gas do the
conversion at this point. See the ‘Conversion to LP Gas’ section
of these instructions.
Fig.5-4
Fig.5-2