1. DL manuals
  2. Ranger Products
  3. Air Compressor
  4. R7580H-601
  5. Installation And Operation Manual

Ranger Products R7580H-601 Installation And Operation Manual

Summary of R7580H-601

  • Page 1

    Forward this manual to all operators. Failure to operate this equipment as directed may cause injury and/or property damage. Installation and operation manual shipping damage claims when this equipment is shipped, title passes to the pur- chaser upon receipt from the carrier. Consequently, claims fo...

  • Page 2

    Upon delivery 1. Carefully remove all packaging material. 2. Inspect the equipment and all parts for any signs of concealed shipment or storage damages. 3. Remember to report any shipping damage to the carrier and make a notion on the delivery receipt. Important safety instructions u· read all warni...

  • Page 3

    Specifications / features professional: models: r7580h-601 / r7580h-603 / r7580v-601 / r7580v-603 motor max psi/bar max cfm @ 90 psi/lm max cfm @ 175 psi/lm standard voltage* pump design speed (rpm) tank 7.5hp 5.5 kw 175 psi 12 bar 26.5 cfm 750lm 25.5 cfm 723 lm 208-230v / 60 hz 1 phase tri-max™ 3 c...

  • Page 4

    Belt adjustment: install the triangular belt and adjust it so when pres- sure is applied onto center, there should be 1/2” (approx.) slack. See sketch note: if the belt is installed too tightly, overloading of the motor will occur. This will cause the motor to overheat. If the belt is installed too ...

  • Page 5

    Initial start-up procedure: open the air receiver service valve to permit air to escape, preventing air pressure build-up in the air receiver. Plug power supply cord into correct power source. Close air receiver service valve. Your compressor is now ready for operations. Run the compressor for a min...

  • Page 6

    Trouble possible cause corrective action no start condition fuse blown or circuit breaker tripped loose electrical connection overheated motor check for cause of blown fuse or breaker and replace or reset check wiring connections press reset button or wait for automatic reset. Check v belt tension. ...

  • Page 8: List

    No. Parts no. Description q'ty no. Parts no. Description q'ty 1 01ut75 pump 1 36 4005553 ele.Cable 1 2 60051240 bolt 4 37 4017y254 pres. Adjt connecter 4 3 600112 spring washer 4 38 400522 ele.Cable 1 4 501019870 exhaust assembly 1 39 4005553 ele.Cable 1 5 20t300tc44 air tank 1 40 60051225 bolt 2 6 ...

  • Page 10

    No. Parts no. Description q'ty no. Parts no. Description q'ty 1 01uv75 pump 1 35 30103412 safety valve 1 2 60051040 bolt 4 36 3004111t pressure switch 1 3 600110 spring washer 4 37 203314a nipple 1 4 501019485 exhaust assembly 1 38 4017y254 pres. Adjt connecter 5 5 20t250v302 air tank 1 39 4005553 e...