Rangerx Xplore User Handbook Manual - page 27
FIELD SERVICES / MANUFACTURING / WAREHOUSING / PUBLIC SAFETY / TRANSPORTATION / DISTRIBUTION / UTILITIES / ENERGY / TELCO & CABLE
RangerX User’s Handbook
27
Troubleshooting
___________________________________________________________________
Table 7 Troubleshooting
___________________________________________________________________
Problem Possible
causes
and
solution
________________________________________________________________________________________________________
Computer will not start
- The battery may be defective or discharged to a critically low level.
Connect an external power supply (such as the AC adapter) oR
install a charged battery. See “Using the battery” on page 54.
- Internal components may be above or below the acceptable
operating range (below -20° C or above 60° C). After the
temperature returns to safe operating range the computer will
start.
________________________________________________________________________________________________________
The Computer will not resume operation
-The battery may be defective or discharged to a critically low level.
When the battery reaches a critically low level, the computer is
forced into Suspend- to-RAM mode to avoid a total system power
failure. Connect an external power supply (such as the AC adapter)
or install a charged battery. See “Using the battery” on page 54.
-The computer may be at the critical thermal limit. To avoiddamage
to heat-sensitive components, the computer enters Suspend-to-
RAM mode when the computer operates above 60° C. Operation
automatically resumes when the computer cools to below 60° C.
Move the computer to a cooler location.after being suspended
________________________________________________________________________________________________________
The Status LED is red, continuous
- The computer is on, running under battery power, and the charge
level in the battery has reached a critical level. Plug the computer
into an AC/DC power source or install a charged battery.
- The system has encountered a fault and is preventing normal
operation.
Contact
your
local
help
desk.
________________________________________________________________________________________________________
The Status LED is red, blinking
The computer is powered on, running under battery power, and the
charge level in the battery is at a minimum warning level. Plug the
computer into an AC/DC power source or install a charged battery.
Table 7 contains solutions to some problems. If you cannot solve the
problem by taking the actions described, contact your local help desk
or your reseller for further assistance.