Rapid Engineering CTHN-100 Installation & operation manual - Warning

CTHN-S

ERIES

 I

NSTALLATION

, O

PERATION

AND

 S

ERVICE

 M

ANUAL

12 of 91 

SECTION 7: GENERAL SUSPENSION DETAILS

To ens

u

re yo

u

r safety and comply 

w

ith the terms of 

the 

w

arranty, all 

u

nits m

u

st be installed in 

accordance 

w

ith these instr

u

ctions.

The gas or the electrical s

u

pply lines m

u

st not be 

u

sed to s

u

pport the heater.

Do not locate the gas or electric s

u

pply lines directly 

over the path of the fl

u

e prod

u

cts from the heater.

The heater m

u

st be installed in a location that is 

readily accessible for servicing.

The heaters m

u

st be installed in accordance 

w

ith 

clearances to comb

u

stibles as indicated on the rating 

plate and in this instr

u

ction man

u

al.

The minim

u

m and maxim

u

m gas inlet press

u

res 

m

u

st be maintained as indicated on the rating plate.

Typical installation config

u

rations are sho

w

n 

on Page 13, Figure 14

.

Expansion and contraction of the t

u

be dictates that 

the minim

u

m s

u

spension lengths m

u

st be 

maintained. 

See table on Page 13, Figure 14.

WARNING

Severe Injury Hazard

Secure burner to burner tube with bolts and 

lockwashers.

Han

g

 heater with materials with a minimum 

workin

g

load of 75 lbs (33 k

g

).

Failure to follow these instructions can result 

in death, injury or property dama

g

e.

WARNING

Cut/Pinch Hazard

Wear protective 

g

ear durin

g

 installation, 

operation and service.

Ed

g

es are sharp.

Failure to follow these instructions can result 

in injury.