Rapid Engineering UHAM 150 Installation, operation & service manual - Warning

SECTION 6: H

EATER INSTALLATION

9 of 59

SECTION 6: HEATER INSTALLATION 

6.1 General 

Heaters are designed for installation above 6' 

(1.8 m). These heaters must be installed within the 

heated space. Duct delivery systems are not 

permitted with axial fan units. When handling or 

supporting the heater from below, ensure that the 

weight is taken at the support points.

The gas or electrical supply lines must not be used 

to support the heater.

Do not locate the gas or electrical supply lines 

directly over the path of the flue products from the 

heater.

The heater must be installed in a location that is 

readily accessible for servicing.

The heater must be installed in accordance with 

clearances to combustibles as indicated on the wall 

tag and in this manual.

6.2 Suspension

For typical suspension, See Page 9, Figure 4.

Figure 4: Suspension Methods

WARNING

Crush Hazard

Use 3/8" threaded rod 

minimum.

Failure to follow these 

instructions can result in 

death, injury or property 

damage.