Raptor Edge System Owner's Manual - Raptor® Edge System
[ 2 ]
RAPTOR® EDGE SYSTEM
Congratulations on your purchase of the Raptor® Edge System!
You have selected an exceptional edge grinder by Surface Prep Super Store. Each component
used in the construction of the Raptor® Edge System was selected to provide you with
superior performance and the highest quality available today. The design of the Raptor® Edge
System makes it easy to use and operate. Please take a few moments to read over the
operating instructions to ensure that you get the best performance from your Raptor® Edge
System and years of trouble-free service.
The Raptor® Edge System is ideal for grinding or polishing concrete, terrazzo, stone, and
masonry or removing paint, thin set, adhesives, VCT, mastic and epoxy floor coatings. Get
right to the edge with the Raptor® Edge System.
Safety:
Personal protection equipment and proper safety attire should be worn when operating your
Raptor® Edge System. All operators should wear approved safety equipment appropriate for
the job such as hard hat, eye protection and safety shoes. Hearing protection should be used
at all times. Keep loose clothing, hands and feet away from moving parts. Failure to do so
could result in dismemberment or death. Maintain a safe operating distance from flammable
materials, sparks from the cutting-action of this machine can ignite flammable materials
or vapors.
Electric Shock:
Extreme care must be taken when operating the Raptor® Edge System with water present.
Ensure power cord is properly grounded, and is attached to a Ground-Fault-Interrupter (GFI)
outlet. Check all electrical cables and make sure all connections are tight and cable is in good
working condition. Be sure cable is correctly rated for both the operating current and voltage of
this equipment. Improper connection of the equipment can result in a risk of electric shock.
Ordering replacement parts for your Raptor® Edge System:
To order replacements parts, please call our headquarters located in Denver, Colorado, Toll-
Free (800) 945-4016. Part numbers and parts list is on page 8 of this manual. Refer to the
model number and serial number located on the back of your Raptor® Edge System.
Surface Prep Super Store
855 East 68
th
Avenue | Denver CO 80229
Office (303) 426-0006 | (800) 945-4016 | (303) 426-4803 Fax
info@surfaceprepsuperstore.com | www.surfaceprepsuperstore.com
Patent Pending
WARNING!
PLEASE READ BELOW - IMPORTANT SAFETY INFORMATION
WARNING!