Raptor RAP 225 Instruction manual - Care And Maintenance
11
PROBLEM/
INDICATION
POSSIBLE CAUSE
SUGGESTED SOLUTION
Power tool will not
operate when plugged
into inverter
Excessive start-up load
Power tool (or appliance) draws too
much voltage; and cannot be used with
your inverter.
Resetting the Inverter
After over-voltage or thermal automatic shutdown, your inverter will require a manual reset. To manually reset
the inverter, turn the ON/OFF Switch to the off position, then back on.
CARE AND MAINTENANCE
Storage
1. Ideal storage temperature range is 50-68°F (10-20°C).
2. Store and use the inverter in a cool, dry place with adequate ventilation.
3. Avoid locations that are exposed to heating units, radiators, direct sunlight or excessive humidity or dampness
.
Fuse Replacement
Your inverter is equipped with multiple internal fuses. Normally, these fuses will not “blow” unless there is a serious
problem inside the unit.
Internal fuses are replaceable; however, only trained personnel should attempt fuse
replacement.
Refer to the “Service Information” section of this Instruction Manual.
Preventive Maintenance
Inverters require minimal maintenance. For optimum performance, the manufacturer recommends periodically
performing the following preventive maintenance.
1. Turn the inverter off using the front panel On/Off Switch.
2. Check and tighten all electrical connections, including the ground.
3. Using a non-metallic vacuum cleaner hose, vacuum the air slots and fan area.
4. Clean the outside of the unit using a damp (not wet) cloth.
5. Wipe unit surfaces thoroughly with a dry cloth.
6. Resume operation.
ACCESSORIES
If you need assistance regarding accessories, please visit www.raptorusa.com.
WARNING:
The use of any accessory not recommended for use with this tool could be hazardous and will void
manufacturer’s warranty.
SERVICE INFORMATION
To locate your nearest service location or for details on replacement parts, contact the manufacturer at
www.raptorusa.com