1. DL manuals
  2. Raritan
  3. Media Converter
  4. AUATC
  5. Installation And Operation Manual

Raritan AUATC Installation And Operation Manual

Manual is about: ASCII Terminal Converter

Summary of AUATC

  • Page 1

    Installation and operation manual auatc rackit ® technology corporation 274 madison avenue, new york, ny 10016 tel: (212) 679-0050 • fax: (212) 679-0040 1 . 8 0 0 . 6 3 6 . 3 4 3 4 www.Rackittechnology.Com technology corporation ® supported by:.

  • Page 2

    This page intentionally left blank..

  • Page 3: Installation and

    Installation and operation manual auatc l i s t e d c u s l u 1f61 i.T.E. Copyright ©2003 raritan computer, inc. Atc-0b-e october 2003 255-33-0001 raritan computer inc. 400 cottontail lane somerset, nj 08873 usa tel. 1-732-764-8886 fax. 1-732-764-8887 sales@raritan.Com http://www.Raritan.Com raritan...

  • Page 4

    This page intentionally left blank..

  • Page 5: Fcc Information

    Fcc information this equipment has been tested and found to comply with the limits for a class a digital device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful interference in a commercial installation. This equipment generates, uses,...

  • Page 6

    This page intentionally left blank..

  • Page 7: Table of Contents

    T able of c ontents i table of contents c hapter 1: i ntroduction ...........................................................................1 auatc overview ....................................................................................................................1 product photos.............

  • Page 8: Table of Figures

    Ii t able of f igures table of figures figure 1 ps/2 keyboard/monitor terminal ....................................................................................................4 figure 2 auatc with a kvm switch .........................................................................................

  • Page 9: Chapter 1: Introduction

    C hapter 1: i ntroduction 1 chapter 1: introduction auatc overview congratulations on your purchase of raritan’s auatc terminal converter! The auatc is designed to emulate an “ascii terminal,” converting rs232 serial ascii terminal data to ps/2 keyboard and vga video or sun keyboard and sun video. T...

  • Page 10

    2 auatc u ser m anual.

  • Page 11: Chapter 2: Installation

    C hapter 2: i nstallation 3 chapter 2: installation follow these steps to install the auatc. 1. Boot your ascii device, if necessary, and configure a serial port to: vt100, 9600-baud rate, no parity, 8-bit data, 1 stop bit. 2. Using the db25 (m/f) null modem cable included, connect the ascii device ...

  • Page 12

    4 auatc u ser m anual auatc configuration diagrams figure 1 ps/2 keyboard/monitor terminal figure 2 auatc with a kvm switch.

  • Page 13

    C hapter 2: i nstallation 5 figure 3 auatc with a smx sun kvm switch remote access up to 650’ away the auatc has a raritan cat5 transmitter port (rj45) that enables you to operate a keyboard and monitor up to 650’ away using standard category 5 enhanced utp cable. A raritan cat5 receiver, model urkv...

  • Page 14

    6 auatc u ser m anual.

  • Page 15: Auatc Terminal Converter

    C hapter 3: o perating an ascii d evice with the auatc t erminal c onverter 7 chapter 3: operating an ascii device with the auatc terminal converter this section describes how to access and operate an acsii-based device with a ps/2 or sun console (keyboard and monitor) using the auatc. Screen layout...

  • Page 16

    8 auatc u ser m anual online mode when the auatc is operated in on-line mode (see figure 4), the screen area displays your interactions with the ascii device. This mode of operation is similar to using an ascii terminal to access and operate an ascii device. Simultaneously, the output data stream fr...

  • Page 17

    C hapter 3: o perating an ascii d evice with the auatc t erminal c onverter 9 buffer edit mode the auatc stores the most recent eight pages of data from the ascii device in a circular buffer. You can edit the data in the buffer. To operate the auatc in edit buffer mode, press the alt-f4>. The auatc ...

  • Page 18

    10 auatc u ser m anual set-up operations press alt-f2> to set up the serial communication parameters and the selection of video output (see figure 7). You can change the serial communication baud rate and transmission format to meet your device needs. You can also choose to use a vga monitor in conj...

  • Page 19: Appendix A: Faq

    A ppendix a: faq 11 appendix a: faq p roblem s uggested s olution i do not get a device prompt (a) check all connectors and make sure the 6v dc power supply is connected securely. (b) if you have the auatc screen displayed with top and bottom help windows, make sure the status indicates “on line”. I...

  • Page 20

    12 auatc u ser m anual 255-33-0001.