Rasmussen 18DFC7-ME-N General Assembly, Installation, And Operation Instructions - page 13
13
Propane
Thermocouple
Air Intake Port
B) Natural Gas Pilot Assembly (ODS-OP-N)
Pilot Tube
Piezo Sparker
Air Intake Port
Piezo Sparker
Thermocouple
Tip
A) Propane Pilot Assembly (ODS-OP-P)
Pilot Tube
Models mfg’d from 6/99 thru 01/08
A) Propane Pilot Assembly (ODS-ROP-P)
Pilot
Tube
A) Propane Pilot Assembly (ODS-CN-P)
Models mfg’d from 01/08 to present
Air Intake Port
Piezo Sparker
Thermocouple
Tip
Pilot Tube
B) Natural Gas Pilot Assembly (ODS-CN-N)
(Red dot)
Air Intake Port
Piezo Sparker
Thermocouple
Tip
Pilot Tube
(Blue dot)
Propane
Thermocouple
Air Intake Port
B) Natural Gas Pilot Assembly (ODS-ROP-N)
Piezo Sparker
Thermo-generator
Air Intake Port
Piezo Sparker
Thermocouple
Tip
Pilot
Tube
Thermo-generator
STEP FIVE: LIGHTING AND OPERATION (ALL MODELS)
VALVE PLUG (“ME” MANUAL “EASY” CONTROL) SHOWN, ALSO
LOCATION FOR;
●
ON/OFF SOLENOID (“SE” REMOTE READY MODELS) OR
• DC MOTOR DRIVE (“RE” VARIABLE FLAME HEIGHT MODELS)
BOTH SHOWN ON FOLLOWING PAGE.
FIGURE 17
FIGURE 13
1. Slightly push in the “EASY” Safety Valve Knob, located on the front right side of the CHILLBUSTER™ face plate
(Figure 13 and Figure 14A), and turn clockwise to “OFF”.
2. Before lighting, wait at least five minutes to allow gas which may have accumulated around burner to escape, then
slightly push in the “EASY” Safety Valve Knob and turn to “PILOT/OFF” (Figure 14).
3. Depress knob until air dissipates and gas flows to pilot. Press the Piezo Ignitor Button to light the pilot (Figure 15),
and continue to hold knob in until pilot remains lighted after knob is released. The Pilot flame should be steady and
soft blue surrounding 1/8 inch of the thermocouple tip and extending approximately 1 inch beyond the pilot tube as
shown in Figure 17 below.
4. Slowly turn knob to “ON” (Figure 14) to light the burner.
5. If burner(s) fails to light or if pilot goes out, repeat steps 1 through 4.
6. Adjust the burner flame height by turning the “EASY” Safety Valve Knob clockwise to lower and counter-clockwise
to raise up to full on.
7. For complete shutdown, push “EASY” Safety Valve in and turn to OFF”.
A) “EASY” Safety Valve Knob
“EASY” Safety Valve
B) Pilot Adjustment
Screw
C) Knob Position
Indicator
OFF/LOWER
FULL ON
Face Plate
Piezo Ignitor Button:
Pilot Flame Ignition.
FIGURE 14
FIGURE 15