Rasmussen Chillbuster 7 User Manual - page 14
14
Propane
Thermocouple
Air Intake Port
B) Natural Gas Pilot Assembly (ODS-OP-N)
Pilot Tube
Piezo Sparker
Air Intake Port
Piezo Sparker
Thermocouple
Tip
A) Propane Pilot Assembly (ODS-OP-P)
Pilot Tube
Models mfg’d from 6/99 thru 01/08
A) Propane Pilot Assembly (ODS-ROP-P)
Pilot
Tube
A) Propane Pilot Assembly (ODS-CN-P)
Models mfg’d from 01/08 to present
Air Intake Port
Piezo Sparker
Thermocouple
Tip
Pilot Tube
B) Natural Gas Pilot Assembly (ODS-CN-N)
(Red dot)
Air Intake Port
Piezo Sparker
Thermocouple
Tip
Pilot Tube
(Blue dot)
Propane
Thermocouple
Air Intake Port
B) Natural Gas Pilot Assembly (ODS-ROP-N)
Piezo Sparker
Thermo-generator
Air Intake Port
Piezo Sparker
Thermocouple
Tip
Pilot
Tube
Thermo-generator
FIGURE 15
STEP FIVE: LIGHTING AND OPERATION (ALL MODELS)
VALVE PLUG (“ME” MANUAL “EASY” CONTROL) SHOWN, ALSO
LOCATION FOR;
●
ON/OFF SOLENOID (“SE” REMOTE READY MODELS) OR
• DC MOTOR DRIVE (“RE” VARIABLE FLAME HEIGHT MODELS)
BOTH SHOWN ON FOLLOWING PAGE.
FIGURE 17
FIGURE 16
A)
FIGURE 14
1. Slightly push in the “EASY” Safety Valve Knob, located behind the CHILLBUSTER™ face plate on the right side
(Figure 14), and turn clockwise to “OFF”.
2. Before lighting, wait at least five minutes to allow gas which may have accumulated around burner to escape, then
slightly push in the “EASY” Safety Valve Knob and turn to “PILOT/OFF” (Figure 15).
3. Depress knob until air dissipates and gas flows to pilot (located on the right side behind the front burner). Press the
Piezo Ignitor Button to light the pilot (Figure 16A), and continue to hold knob in until pilot remains lighted after knob
is released. The Pilot flame should be steady and soft blue surrounding 1/8 inch of the thermocouple tip and
extending approximately 1 inch beyond the pilot tube as shown in
Figure 16 below.
4. Slowly turn knob to “ON” to light the burner.
5. If burner(s) fails to light or if pilot goes out, repeat steps 1
through 4.
6. Adjust the burner flame height by turning the “EASY” Safety Valve
Knob clockwise to lower and counter-clockwise to raise up to full on.
7. For complete shutdown, push “EASY” Safety Valve in and turn
to OFF”.
Piezo Ignitor Button:
Pilot Flame Ignition.
“EASY” Safety Valve Knob
“EASY” Safety Valve
B) Pilot Adjustment
Screw
C) Knob Position
Indicator
OFF/LOWER
FULL ON
Face Plate