Rasmussen Chillbuster Magnum Series Assembly, installation and operation instructions - page 7
ALL APPLICATIONS (VENTED and VENT FREE OPERATION)
Ember Material Preparation And Placement (Models C2A and C2B):
1. Prepare the ember material by
pulling apart into loose pieces (not
tight clumps) the size of a dime. S e e
Figure 5.
2.
Place the loose pieces in the
ember tray, building a ramp which
completely covers the Front
Burner. The loose clumps should
be no more than one to two pieces of
ember material in depth. The looser
the pieces, the better the glowing
Ember Material Actual Size
Figure 5
ember effect! See Figure 6.
3.
Excess embers may be placed on
each side of the Front Burner to
hide the burner/grate attachment
points.
Ember material is only for use
with the Front Burner.
Front
Burner
Ember
Tray
Ember
Material
Ember
Tray
Attaching
Point
Figure 6
WARNING: Excessive amounts of Ember Material or Ember Material which is too tightly packed can result in
decreased combustion performance and elevated levels of carbon monoxide. Looser pieces of Ember
Material produce more efficient combustion performance and enhance the overall glowing ember effect.
LOG PLACEMENT
ALL MODELS
1. Place largest log (FRONT LOG) in the front of the grate and the second largest log (REAR LOG) on the rear of the
grate behind the LOCATOR PINS. (Figures 5 and 6).
2.
Place both Right and Left LARGE TOP LOGs across the FRONT and REAR logs with the LOCATOR PINS
inserted into the drilled holes located on the bottom of both LARGE TOP LOGs. (Figures 5 and 6).
3.
With REAR LOG center pin inside hole, place CENTER "Y" LOG across FRONT and REAR logs as shown.
To ensure optimum performance, logs must be placed on Burner as depicted.
Rear Log
Top Log
(L)
Top Log
(R)
Front Log
v
v
v
v
v
v
v
Middle
Log
Rear Locator
Pin
Drilled Hole
Drilled Hole
Rear Log
Top Log (R)
Top Log (L)
............
Middle Log
Front Log
Front Log L
Top Log (R)
Top Log (L)
Middle Log
Figure 7
Figure 8
WARNING: Failure to position parts in accordance with these diagrams
or failure to use only parts specifically approved with this heater
may result in property damage or personal injury.
7