Rath 2100 Series Installation & Operation Manual - Phone Programming
Page 3
1. After configuration, place a test call from analog phone connected to phone port
2. If test call is successful, VoIP Phone is ready for programming
3. 2100 Phone can be plugged in at this time
7. Change IP address settings of VoIP Phone
a. Click
BASIC SETTINGS under the menu options on the top of the screen
b. Under IP address, click on circle next to
Statically Configure As
c. Enter desired IP address, subnet mask, and default router for VoIP Interface
d. Select proper time zone from drop down menu next to
Time Zone
8. Click APPLY at the bottom of the page
9. Enter SIP Server information in VoIP Phone
a. Click FXS Port under the menu options on the top of the screen
b. Enter IP address of SIP Server in Primary SIP Server box
c. Enter SIP Extension ID in SIP User ID box
d. Enter Authentication ID in Authenticate ID box (can be the same as the SIP Extension ID)
e. Enter Authentication Password in Authenticate Password box
f. Fill in the NAME location as it will appear on the phone
10. Click APPLY at the bottom of the page, then click REBOOT to restart unit
Phone Programming
Keypad
Testing:
On-Site Programming:
Step 1. To Begin Program Mode
A. Press
Enter
Step 2. To Program Emergency Numbers
A. Press
1, Enter, (phone number), Stop
Note: To program numbers 2-5, repeat step 2A
Step 3. To Program Location Message
A. To turn on message Press
1, 3, Enter, 2
B. Press
6, Record (speak message) Stop (to replay message
Press 6, Play)
C. Program frequency of message Press
1, 3, Enter, __
0 = Turn message off
1 = Plays message (1) time
2 = Plays message (2) times (default)
3 = Plays message until receiving party presses * on their phone
Step 4. To Program Auto Disconnect Time (Default is 5 minutes, lowest interval is 1 minute)
A. Press
8, Enter, (3 digit number in minutes)
Ex: 2 minutes = 002
Step 5. To Exit Program Mode
A. Press
Stop for 3 seconds
Push the emergency button to activate the VoIP Phone: