Ratiotec RTP 300 Instruction Manual - Setting The Baud Rate
10
10
11
11
Setting the baud rate
Safety recommendations
Note: Most ratiotec devices work with a baud rate of 9600 bps. Change the baud rate only if you
are working with a product the baud rate of which differs from 9600 bps.
To change the baud rate, please proceed according to the following steps:
1 . When off: Press POWER until all three indicating lights light up .
2 . Press POWER again . The red error light blinks .
3 . Press FEED to set baud rate (see chart below) .
4 . The power light blinks as many times as you have pressed the FEED key .
E .g . If you have pressed FEED once, baud rate is 2400 and the power light blinks once .
5 . Press POWER to confirm and exit .
Times “FEED” pressed
Baud Rate
Blinking Times
1 x
2400
1 x
2 x
4800
2 x
3 x
9600
3 x
4 x
19200
4 x
5 x
38400
5 x
6 x
57600
6 x
Overheating protection
The printing head contains overheating protection . When temperature is too high, printer will
automatically stop and its error light will light up . After cooling down, it will restart and resume
printing .
!