Installation and operation ki-1976 mcx300 am-fm tuner and cassette tape player rauland-borg corporation issued: 07/01/98 page 1 of 8.
Copyright 1998 by rauland-borg corporation, all rights reserved. This document contains user’s information on technology that is proprietary to rauland-borg corporation. Permitted transmittal, receipt, or possession of this document does not express license or imply any rights to use, sell, design o...
Mcx300 am-fm tuner and cassette tape player—installation and operation page 3 of 8 (jul-98) table of contents general information .............................................................................................................................................. 4 ' (6&5,37,21 ...............
Mcx300 am-fm tuner and cassette tape player—installation and operation page 4 of 8 (jul-98) general information 'hvfulswlrq the rauland mcx300 am-fm tuner and cassette tape player comes ready to be rack-mounted. It includes a separate 12-vdc power supply that can be plugged into any convenient 120-v...
Mcx300 am-fm tuner and cassette tape player—installation and operation page 5 of 8 (jul-98) 3dfnlqj/lvwdqg8qsdfnlqj3urfhvv the mcx300 comes completely assembled. The only separate items besides the main chassis are the am/fm cassette receiver manual, the 12-vdc power supply and the screws, washers, ...
Mcx300 am-fm tuner and cassette tape player—installation and operation page 6 of 8 (jul-98) of the radio signals in the area. For most installations, rauland recommends the antenna system shown in the attached wiring diagram, km0710. Important: the system should be installed with some protection aga...
Mcx300 am-fm tuner and cassette tape player—installation and operation page 7 of 8 (jul-98) audio adjustments can be tried initially. Make adjustments as needed to obtain the desired performance. You may find it helpful to play the unit through its monitor speaker for the initial settings. Important...
Mcx300 am-fm tuner and cassette tape player—installation and operation page 8 of 8 (jul-98) 9 the “monitor” position plays the unit through the front-panel speaker. 9 the “program” position plays the unit through the interconnected system. 9 the “program/monitor” position plays the unit through both...
Example of antenna grounding per national electrical code instructions. Il0153 - 0 notes: 1. Use #10 awg copper, #8 awg aluminium, or #17 awg copper-clad steel or bronze wire (or larger) as ground wire for both mast and lead-in. 2. Secure the lead-in wire from the antenna to the antenna discharge un...
Combined signal to tuner from fm antenna lightning arrestor qc0126 from am antenna am/fm antenne coupler housing to earth ground.
