Summary of 12’ Saturn
Page 1
12’ saturn™ owner’s manual water sports equipment.
Page 2
• inflation, set up and supervision must be done by a mature and knowledgeable adult! • inspect product for any unsafe conditions before use! Do not use if repair is needed! • instruct children on proper use of this product. • over-inflation is the major cause of leaks. Do not inflate with an air co...
Page 3
Warning! Do not over-inflate!! Product should not be firm! There should be a depression when pushed on with your hand. Please note: keep in mind the temperature of the air going into the product and the outside air. If your inflator is hot and sending warm air into the product, when it cools, it wil...
Page 4: 12’ Saturn
12’ saturn parts: 1 – saturn 1 - repair kit consisting of: 4 oz of glue, 2 – 8” square, patch of each in white and blue position: make sure water depth is a minimum of 8 feet deep. There should also be a minimum of 16 feet clearance all around the unit. Recommended maximum weight: 1000 lbs. Recommen...
Page 5: Inflation
Inflation set up and supervision must be done by a mature and knowledgeable adult! You can use the following devices to inflate the product: • electric inflator/deflator (household current). Rave recommends the high speed inflator/deflator, item #01083. Caution: use extreme care when using an electr...
Page 6: Special Adaptor.
A special inflation adaptor is included with this product. If you are using the rave sports high speed inflator (item #01083), simply lock the adaptor onto the end of the inflation hose and insert into the valve body. Turn ¼ turn to lock in place. Note: this inflation adaptor will automatically open...
Page 7: Anchoring
Anchoring due to extreme varieties of conditions, anchor line and anchors are not included with the product and must be purchased separately. Attach the anchor line (not included) securely to the anchor ring(s) on the bottom of the product. The number of anchor attachment points will vary per model....
Page 8
Cord will provide 2-3 ft. Of stretch to absorb waves and any vertical motion. Note: more slack in the anchor line may improve anchor holding performance, but too much slack may allow the product to flip over in strong winds. For best results, maximize your anchor holding power via more weight or a d...
Page 9: Deflation
Deflation prior to deflation, remove all children from the unit! Use one of the inflator/deflator devices recommended in the “inflation” section for faster deflation. Halkey roberts valve - unscrew the cap by twisting counterclockwise to expose the air valve stem. Open the air valve by pushing in th...
Page 10: Cleaning
Cleaning if your inflatable is used intensively, then it should be cleaned on a weekly basis. It is also important to clean and dry the product before it is packed away. When cleaning your product never use strong detergents or silicone- based products. Also never use high pressure cleaning equipmen...
Page 11: Repairs
Please note: rodents, such as mice, chew on fabric, including inflatable material. As a precaution you can place moth balls or fabric softener sheets around the products during storage to deter them. Repairs all of the inflatable products include a repair kit. You can easily repair minor punctures a...
Page 12: Tip
Tip – place glue on the dull side of the patch and to the shinny side of the unit. Then when you apply the patch it will match. Tip – use a short brush (just cut the length off) as this digs into the material better to spread the glue. Also try to use a brush with real hair instead of synthetic. Ste...
Page 13: Warning
Warning • this is not a lifesaving device! • always use a u.S. Coast guard approved (personal floatation device) vest for children and adults! • do not leave children unattended while in use! • this product should only be used under mature and knowledgeable adult supervision at all times! • always i...