Summary of Bongo 10-Foot
Page 1
Bongo™ owner’s manual 10-foot model (shown) 13-foot model.
Page 2: Table Of Contents
1 table of contents introduction ............................................................................... 2 safety rules and information..................................................... 3 inflating your bongo ................................................................ 6 assembling an...
Page 3: Introduction
2 introduction water sports can be safe and fun for all levels of enthusiasts. The owner’s manual is presented to enhance your enjoyment of the sport. It is intended to alert you to some of the potentially dangerous conditions that can arise in all water sports. Please take a few minutes to read thi...
Page 4
3 safety rules and information • read and understand all of the information contained in this owner’s manual before assembling and using your product. • make sure that everyone who uses the product is provided with and understands these safety rules and information. • the bongo is designed to be use...
Page 5
4 either product, allow only one person (240 lbs. Max) to bounce on the bongo at one time. • never swim or play under or around the bongo. • never dive off of the bongo head first. If you choose to jump off the product, always enter the water feet first. • never use the product while tired or fatigu...
Page 6
5 • do not over inflate. Over inflation can cause seam rupture. • when using on land, always maintain adequate clearance from hard surfaces or obstructions above and around this product. Use on soft sand or place shock-absorbing material around ground perimeter..
Page 7: Inflating Your Bongo
6 inflating your bongo step 1 lay the bongo on a flat surface. Make sure there are no sharp objects under the product that might puncture the tube. Step 2 locate the valve of the bongo and unscrew the cap. We recommend using the high speed inflator/deflator from rave sports to inflate and deflate. (...
Page 8: Note:
7 vacuum for inflation. Insert the adapter into the air valve and lock into place by turning clockwise. Inflate until the tube is firm and resistant to pressure. Your fist should create only a slight depression when pushed against the tube and the surface should be stretched taut in all directions. ...
Page 9: Attaching The Ladder
8 attaching the ladder step 1 the ladder consists of two pieces: a ladder with straps and a molded plastic ladder stabilizer. Orient the stabilizer on the notched side of the top two ladder steps and the curved portion is facing upwards towards the top of the ladder. While maintaining this orientati...
Page 10: Step 4:
9 step 4: to use on water, attach the ladder in the center of the blue panel to the left of the yellow panel that contains the air valve. The warning label on the bounce surface must be visible to anyone climbing the ladder. Attach the ladder by looping the quick link, and webbing around bongo lacin...
Page 11: Step 5
10 important: it is critical that you loop the webbing properly around the rope so that they do not rub against the vinyl (see photos). Step 5 when properly installed, the ladder will hang with the curved portion of the stabilizer against the underside of the bongo. Correct. The left side of the lad...
Page 12: Step 6
11 step 6 attach an anchoring device to the ring or mount on the inner surface of the tube just above the water line, opposite of the ladder. Note: for seasonal anchoring situations, it is important to use an anchor weighing a minimum of 80 lbs. The bongo is now ready to use! Please read and follow ...
Page 13: Cleaning And Storage
12 cleaning and storage when the inflatable product is not being used, store it in a covered, shaded area. This will help protect it against ultraviolet (uv) rays and extend the life of the product. Clean the inflatable completely with a mild soap and fresh water. Never use petroleum based products ...
Page 14: Repairs
13 repairs for large holes, tears or seam failures, contact rave sports customer service at 1-800-659-0790. Additional patches may be purchased at www.Ravesports.Com. For minor holes or tears: inflate the product and locate the leak by spraying the tube with mild soapy water. Determine the hole size...
Page 15
14 this page intentionally left blank..
Page 16
15 www.Ravesports.Com rave sports a revel match, llc company 3325 labore road saint paul, minn 55110 800.659.0790 april 2011.