Rave Sports Bongo Owner's Manual

Manual is about: 10 and 13 foot models

Summary of Bongo

  • Page 1

    Bongo™ owner’s manual 10-foot model (shown) 13-foot model.

  • Page 2: Table of Contents

    Table of contents introduction ............................................................................. 2 safety rules and information ................................................. 3 inflating your bongo ™ ........................................................... 5 assembling and attachin...

  • Page 3: Introduction

    Introduction water sports can be safe and fun for all levels of enthusiasts. The owner’s manual is presented to enhance your enjoyment of the sport. It is intended to alert you to some of the potentially dangerous conditions that can arise in all water sports. Please take a few minutes to read this ...

  • Page 4: Safety Rules and Information

    3 safety rules and information • read and understand all of the information contained in this owner’s manual before assembling and using your product. • make sure that everyone who uses the product is provided with and understands these safety rules and information. • the bongo is designed to be use...

  • Page 5

    • never dive off of the bongo head first. If you choose to jump off the product, always enter the water feet first. • never use the product while tired or fatigued. Use extreme caution while swimming between the shore and the product. Do not attempt to swim this distance if you are tired or fatigued...

  • Page 6: Inflating Your Bongo

    Inflating your bongo step 1: lay the bongo on a flat surface. Make sure there are no sharp objects under the product that might puncture the tube. Step 2: locate the valve of the aqua bongo and unscrew the cap. We recommend using the high speed inflator/deflator from rave sports to inflate and defla...

  • Page 7: Note:

    Port of the vacuum for inflation. Insert the adapter into the air valve and lock into place by turning clockwise. Inflate until the tube is firm and resistant to pressure. Your fist should create only a slight depression when pushed against the tube and the surface should be stretched taut in all di...

  • Page 8: Attaching The Ladder

    Attaching the ladder step 1: curved portion the ladder consists of two pieces: a ladder with straps and a molded plastic ladder stabilizer. Orient the stabilizer on the notched side of the top two ladder steps and the curved portion is facing upwards towards the top of the ladder. While maintaining ...

  • Page 9: Step 4:

    Step 4: to use on water, attach the ladder in the center of the blue panel to the left of the yellow panel that contains the air valve. The warning label on the bounce surface must be visible to anyone climbing the ladder. Attach the ladder by looping the quick link, and webbing around bongo lacing ...

  • Page 10: Step 5:

    Important: it is critical that you loop the webbing properly around the rope so that they do not rub against the vinyl (see photos). Correct. The left side of the ladder should be attached to the left of the black loop. (the right side of ladder, not shown, should be to the right of the black loop.)...

  • Page 11: Step 6:

    10 step 6: attach an anchoring device to the ring or mount on the inner surface of the tube just above the water line, opposite of the ladder. Note: for seasonal anchoring situations, it is important to use an anchor weighing a minimum of 80 lbs. The bongo is now ready to use! Please read and follow...

  • Page 12: Cleaning and Storage

    11 cleaning and storage ƒ when the inflatable product is not being used, store it in a covered, shaded area. This will help protect it against ultraviolet (uv) rays and extend the life of the product. ƒ clean the inflatable completely with a mild soap and fresh water. Never use petroleum based produ...

  • Page 13: Repairs

    12 repairs for large holes, tears or seam failures, contact rave sports customer service at 1-800-659-0790. For minor holes or tears: inflate the product and locate the leak by spraying the tube with mild soapy water. Determine the hole size and cut a patch 1-2 inches wider than the diameter of the ...

  • Page 14

    13 return authorization policy 1. Customer agrees to ship the product covered by the return authorization (r/a) number within thirty (30) days of receipt of the r/a number. Customer understands that failure to ship the product within thirty (30) days will result in the forfeiture of the r/a. Rave sp...

  • Page 15

    14 lifetime warranty the lifetime warranty set forth below is given by rave sports, inc. With respect to product(s) purchased and used in the united states and internationally. Rave sports’ reinforced pvc product(s), when delivered to you in a new condition in original container, are warranted again...

  • Page 16: 3325 Labore Rd.

    3325 labore rd. St. Paul, mn 55110 800-659-0790 www.Ravesports.Com march 08 15.