Ravenheat CSI 120 User Manual

Supplied By www.heating spares.co  Tel. 0161 620 6677

ESCAPE OF GAS

    Should a gas leak be suspected, contact your gas 

    supplier  without    delay.

    Do NOT search for gas leaks with a naked fl ame.

    WARNING: This appliance must be earthed.  Do not touch

      or tamper with this sealed unit or its components.

     1.         INTRODUCTION 

1.1       Please carefully read information given in the booklet to 

                  help you again maximum control from your appliance 

                  with   minimum  trouble and cost.

     1.1.1Your Ravenheat Condensing Low Nox Combination 

                  Boiler  has  been  designed to supply your Central 

                  Heating and   Domestic Hot  Water directly from one 

                  unit. When Central Heating is operating, the circulation 

                  will be  interrupted when Domestic Hot Water is being 

                  drawn off.

                  This will normally not affect the level of Heating.

PLEASE NOTE

Due to the high effi ciency and resulting low fl ue gas 

                  exhaust temperature a white plume of condensation 

                  vapour (cool steam) will be emitted from the fl ue outlet 

                  terminal, this is quite normal. It will be particularly evident 

                  during periods of low outdoor temparatureor when the 

                  boiler is working at its optimum performance

                  (Plume Management kit is available on request)

                  IMPORTANT : In the event of overheat of fl ue gas 

                  exhaust temperature, for to prevent malfunction of the 

                  appliance, boiler will be stop to operate.           

1.2     CLEARANCES AROUND THE BOILER       

                 Above 125 mm   ( 5  inches)

                 Below  150 mm   ( 6  inches)

                 Front    450 mm  (18  inches)

                 Sides        5 mm  (0.2 inches)

                 25mm (1inch) in front when installed in a cupboard 

    1.2.1   Minimum clearences are required for safety and 

                maintenance. Do NOT obstruct any purpose made 

                ventilation opening if boiler has been fi tted in a 

                compartment.

                Never hang clothes,ect, over the appliance

     1.3      USER CONTROLS (Fig.1) 

1.3.1  This appliance is designed to operate with the 

                 minimum of attention by the User. All the controls 

                 are to be found on the control panel.

     1.4       OPERATING SAFETY CHECKS TO PROTECT 

                 YOUR APPLIANCE

1.4.1   Before lighting the Appliance check Central Heating  

                 system pressure (Fig.1 item 7) is not less than 1 

                 bar. If it is below this do not light but consult your 

                 installer about refi lling your system as you may 

                 have  a leak .

     1.4.2   In the event of malfunction of the appliance will be 

                 indicate by the relevant error code (Table1) on 

                 Digital Display of the control panel (Fig.50).

                 These can be Reset by press a RESET  button .

                 If lockout code persist leave the appliance shut 

                 down and consult your installer/service 

USER’S GUIDE

CSI 120/ 150 (T) Low Nox 

 (with or without built in timer) 

CONDENSING LOW NOX SYSTEM INNOVATION SUPER HIGH EFFICIENTY  AUTOMATIC

    MODULATING COMBINATION BOILER FOR CENTRAL   HEATING AND DOMESTIC HOT WATER

It is the law that all gas appliances are installed by 

a competent person, in accordance with the gas 

safety installation and use current regulations.To 

the current Gas Safety (Installation and Use) 

Regulations B.S.5440:2-(2000).

 All CORGI registered installers carry a CORGI ID card and 

have a registration number. Both should be recorded in your 

boiler Log book. You can check your installer by calling 

CORGI direct on 01256 732300.

Table 1

 01:  Lock out from the Flame Control Unit

 02:  Flue System obstruction

04:  Overheat Lockout

 06: Open or short circuit on Sanitary probe

 12: Open or short circuit on Heating probe

 14: Flame simulation on Flame Control Unit 

 17: Fault on Fan Control

 28: Water Flow Switch Fault or low  pressure  

        in the heating system

 30: Flue temperature fault

  1