M7 gx technical manual 1 raveon technologies corp. R v- m 7 g x g p s t r a n s p o n d e r qu ick -s tart gu id e version c0 february 2010 rv-m7 gx rv-m7 gx wx raveon technologies corporation 990 park center drive, suite c vista, ca 92081 www.Ravtrack.Com www.Raveontech.Com.
M7 gx technical manual 2 raveon technologies corp. 1. Safety / warning information 1.1. Blasting caps and blasting areas to avoid possible interference with blasting operations, turn off this radio or remove the dc power when you are near electrical blasting caps, in a blasting area, or in areas pos...
M7 gx technical manual 3 raveon technologies corp. Gps mode common usage default serial port baudrate output message description gps 1 transponder simple tracking, avl, security. 4800 rmc, gll transmit only in this mode. The receiver is off and gps is turned off between transmissions. This is the lo...
M7 gx technical manual 4 raveon technologies corp. 5. Rs232 serial i/o connector the rs232 9-pin serial i/o connector is a female 9-pin d- subminiature connector having the following pins configuration. It is pinned out so that it may be plugged directly into a computer or pc’s 9-pin com port. Front...
M7 gx technical manual 5 raveon technologies corp. 6.3. Setting a parameter to set a parameter in the m7 gx modem, enter the command mode as described above, then enter the proper command, a space, the parameter, and then a carriage return. For example, to set the destination address of the m7 gx mo...
M7 gx technical manual 6 raveon technologies corp. Athp channel number – select separate channels to minimize interference between multiple sets of modules operating in the same vicinity. Range: 1 - 6 1 atmk address mask – configures local and global address space. Each digit may be a 0,1,2,3,4,5,6,...
M7 gx technical manual 7 raveon technologies corp. 7.1. Gps additional commands to configure gps and tracking features the following commands are unique to the –gx version of the m7. When you execute any of these commands, the new parameter is automatically stored in eeprom. Command command descript...
M7 gx technical manual 8 raveon technologies corp. 8. Setup and initial configuration 1. Connect a dc power source to the dc in connection on the front of the modem. 2. Connect a good quality antenna, cut to the operating frequency, to the bnc connector on the front of the modem. 3. Connect a comput...
M7 gx technical manual 9 raveon technologies corp. Trigdx 500 (tells it to report at the idlerate if it does not move this many meters) txrate 10 ( configures it to report every 10 seconds whenever it is moves more than trigdx meters) 8.3. Device addressing security key the security key programmed i...
M7 gx technical manual 10 raveon technologies corp. 3. Connect a good quality antenna, tuned to the operating frequency, to the rf connector on the front of the modem. Use a quality antenna, and place is at as high-above obstructions as possible. 4. A separation distance of at least 20 centimeters m...
M7 gx technical manual 11 raveon technologies corp. Rv-m7 gx gps modes of operation the gpx x command is used to configure the rv-m7 gx for various common configurations. The following table lists the parameters internal to the rv-m7 gx that are configured and saved when the gps x command is execute...
M7 gx technical manual 12 raveon technologies corp. For technical assistance email or call raveon at: raveon technologies corporation 990 park center drive, suite c vista, ca 92081 760-727-8004 www.Raveontech.Com sales@raveontech.Com.
