Rawlins Floor Master Instructions For Use - page 4
E
C
D
E
B
A
1. Fit the handle grip (A) into the
steel shaft (C) and secure with
the locking screws (B).
2. Fit steel shaft (C) into stirrup
(D) of floor polisher.
3. Secure by inserting locking
screw through the stirrup
and bottom of the steel
shaft and secure with wing
nut.
4. The mains cable can be
wrapped around the cable
holders (E) when not in
use.
2
FLOOR MASTER INSTRUCTIONS FOR USE
ASSEMBLY OF THE
GUIDING HANDLE
SWITCHING ON AND OFF
ON: Release the handle by pressing the
pedal on top of the stirrup and lower
handle into position.
OFF: Move the handle into the vertical
position and lock.
Before use sweep the floor and make sure
that there are no protuding nails or screws
above the floor surface as this will damage
the pads. Buff the floor in a side to side
motion making sure you keep the cable
clear of the machine. During operation the
motor casing will normally become hot.
HANDLE
RELEASE
5
FLOOR MASTER INSTRUCTIONS FOR USE
SANDING
HARD FIBRE BRUSHES
These light coloured hard fibre brushes are
used for wet scrubbing neglected floors and
applying polish into un-sealed floors
(waxing). After use they should be washed
out with warm soapy water.
The sanding discs are used to remove old
wax and polish build up from wooden
floors. The sanding disc set includes a drive
disc and three grades of sanding disc. The
drive discs are used to hold the sanding
discs in place, they are fitted in the same
way as the brushes and only need to be
purchased once. Thereafter only the
relevant sanding discs need to be ordered.
You must ensure that the wood is re-sealed
(waxed) before applying any polish or floor
maintainer.
OPTIONAL ACCESSORIES
Please Note: If scrubbing with the Floor
Master 3 model then a blanking plate is also
required to blank off the blower opening.
This is to avoid water being sucked up into
the appliance. The dustbag should also be
removed.
6934 FM instruction leaflet 19/1/07 11:43 Page 5