Ray Foster MT10 Operating And Maintenance Instructions Manual - Introduction
INTRODUCTION
Thank you for purchasing a quality Foster product. Your Foster Model Trimmer
is designed to give years of trouble free service with minimal care and
maintenance. Before putting your new machine to work, please become familiar
with this operator's manual to obtain maximum performance and satisfaction.
IMPORTANT SAFTEY INSTRUCTIONS
WARNING! When using electrical tools, basic safety precautions should always
be followed to reduce the risk of fire, electrical shock, and personal injury
including the following:
Read and Save this manual for future reference.
Use Proper Grounding. Your Foster Model Trimmer is equipped with a
three-conductor grounded cord and plug. It should be plugged into a three
hole grounded receptacle of the same voltage as inscribed on the machine.
Power Cord. Power supply, plug configuration, and electrical codes vary
from country to country. The cord supplied with your Foster Alloy Grinder is
approved for use in the country of destination. Use only this power cord or
one that is approved for use in your country.
Plug into a Branch Circuit with 16A Circuit Breaker. To reduce the risk of
fire and to protect the units electrical system plug into a branch circuit with a
16 amp circuit breaker.
Disconnect the Power Cord. Before performing any maintenance or repairs
turn the unit off and unplug the power cord to prevent electrical shock or
unintentional starting.
Wear Additional Eye Protection. Protect your eyes from model trimming
debris and the possibility of a fractured wheel by utilizing approved safety
glasses or goggles when operating the Foster Model Trimmer.
Wear Respirator Dust Mask. To protect against the inhalation of dust and
fumes a dust mask should be worn while grinding.
Keep Your Fingers Away From the Grinding Wheel. Use caution when
operating the model trimmer. If the abrasive wheel appears dull, don’t
compensate by applying more pressure, change the wheel.
Always Keep the Door Securely Closed . Be certain that the door is closed
and secured with the door secure knob before turning the machine on.
NEVER turn the motor on with the door open.