Warning this information is a copy of an original archive, therefore aga cannot be held responsible for its continued accuracy..
Wp 10/94 eopi 510661 users instructions consumer protection act 1987 as manufacturers and suppliers of cooking and heating products, in compliance with section 10 of the consumer protection act 1987. We take every care to ensure, as far as is reasonably practical, that these products are so designed...
Dear customer your gas stove is for use on natural gas only and must not be used on any other gas. It must be installed by a competent person (e.G a corgi registered installer) in accordance with the installation instructions and operated in accordance with these users instructions. If so it should ...
The gas to the stove is controlled by a pilot light. Control knob and a safety feature called a flame supervision device. To gain access to the gas control knob, open the control access door (fig. 1). The tap knob bezel is marked with position for (off) (●). Pilot (★) and a graduated section for min...
If the pilot is not already alight, light the pilot as described. Slightly depress and turn the control knob anti-clockwise from the pilot position to the maximum position ( ) (see fig. 5). The fire will ignite. Adjust the heat output as required by turning the control knob clockwise towards the min...
Cleaning should be carried out when the stove is turned off and is cold. The exterior of the stove can be cleaned with a vacuum cleaner, or dusted with a soft brush, either dry or moistened by drawing the bristles over a damp cloth. A cloth is not recommended as it can leave fibres behind. The flame...
6 laying the fuel bed fig. 10 fig. 11 fig. 12.
7 fig. 13 fig. 14 fig. 15.
8 maintenance heat output (gross) replacement items maximum setting minimum setting 7.1 kw 2.25 kw item makers part number control knob hg4m999413 coals pack hg4m420674 turbulator fg4m 420450 aggregate pack tcly417047 door tool hs9m 47520 comp f you require any of the below user replacement items or...