Lifetag system operation guide document reference: 81275-3 date: july 2006 81275_3.Book page 1 friday, july 28, 2006 8:48 am.
Raymarine and seatalk are trademarks of raymarine plc © handbook contents copyright raymarine plc 81275_3.Book page 2 friday, july 28, 2006 8:48 am.
Lifetag system operating guide i important information warnings: lifetag system 1. The raymarine lifetag system is an auxiliary safety system, intended only to provide additional protection to the vessel's crew. Do not rely solely on this system for crew safety; do ensure that all safety instruction...
Ii lifetag system operating guide 81275_3.Book page ii friday, july 28, 2006 8:48 am.
Lifetag system operating guide 1 lifetag system operating guide the lifetag system all tags communicating with base station no alarm signal lost from any tag after 10 seconds alarm sounds signal lost seatalk alarms if your lifetag base station is connected to seatalk, and a lifetag alarm occurs, a s...
2 lifetag system operating guide if a tag is submerged the lifetag system will sound an alarm . . . D8883-1 after a tag button has been held down for 5 sec if you see someone fall overboard, immediately hold down the button on your tag for 5 seconds, to activate the mob alarm if a tag is out of rang...
Lifetag system operating guide 3 if a tag is not active (indicator unlit), press and release the pushbutton to activate the tag. 2. Ensure tags are active 1. Apply power to base station base station getting started before issuing tags to crew members, check each tag to ensure the led indicator brief...
4 lifetag system operating guide color action meaning searching for base station. Wait for a few seconds. If normal operation does not start, check that the base station is switched on. Normal operation. The tag is active and ready for use. Two flashes once every 5 seconds continuous alternating fla...
Lifetag system operating guide 5 what happens when an alarm occurs? When an alarm is initiated to silence an alarm to cancel a lifetag alarm after an alarm 0 1 2 3 4 seconds repeat every 1 s until alarm is silenced the alarm buzzer sounds optional 12 v output other seatalk products note: this will n...
6 lifetag system operating guide i the alarm 'chirps' briefly, every 10 seconds if the base station detects that a tag battery voltage is low: tag low battery warning if this occurs, all users should check their tags for a low battery voltage indication (2 red flashes every 5 seconds). If necessary,...
Lifetag system operating guide 7 looking after your lifetag system d8920-1 never open a tag unless you want to remove or replace the battery. Periodically clean the base station and tags, using a clean damp cloth. Do not use chemical or abrasive cleaning agents. Periodically clean the straps by wash...
8 lifetag system operating guide raymarine uk ltd, quay point, northarbour road portsmouth, hampshire po6 3td, united kingdom. Tel: +44 (0) 23 9269 3611 fax: +44 (0) 23 9269 4642 www.Raymarine.Com raymarine inc, 21 manchester street, merrimack, new hampshire 03054, usa. Tel: +1 603.881.5200 fax: +1 ...
