Raymarine Raystar 112LP Owner's Handbook Manual - Cabling Guidelines
6
Raystar 120 & Raystar 112LP GPS Receivers - Owner’s Handbook
2
In
st
alla
tio
n
Items missing?
If any of the pack items is missing or damaged, please contact your
Raymarine dealer or our Technical Services Department to obtain
replacement parts. Please note that missing or damaged items cannot
be replaced without proof of purchase.
Cabling guidelines
When running cable, always observe the following guidelines:
•
if a cable has to be fed through the deck, use a good quality deck gland
•
where cables are fed through holes, use grommets to prevent chafing
•
secure long cable runs so they do not present a hazard
•
wherever possible, route cables away from fluorescent lights, engines
and radio transmitting equipment, as these may cause interference
Electromagnetic compatibility (EMC) installation
guidelines
All Raymarine equipment and accessories are designed to the best
industry standards for use in the recreational marine environment.Their
design and manufacture conforms to the appropriate Electromagnetic
Compatibility (EMC) standards, but correct installation is required to
ensure that performance is not compromised. Although every effort has
been taken to ensure that they will perform under all conditions, it is
important to understand what factors could affect the operation of the
product.
The guidelines given here describe the conditions for optimum EMC
performance, but it is recognized that it may not be possible to meet all of
these conditions in all situations. To ensure the best possible conditions
for EMC performance within the constraints imposed by any location,
always ensure the maximum separation possible between different items
of electrical equipment.
For optimum EMC performance, we recommended that wherever
possible:
•
Raymarine equipment and cables connected to it are:
•
At least 3 ft (1 m) from any equipment transmitting or cables
carrying radio signals e.g. VHF radios, cables and antennas. In the
case of SSB radios, the distance should be increased to 7 ft (2 m).