1. DL manuals
  2. Raymarine
  3. GPS
  4. Raystar 114
  5. Install Manual

Raymarine Raystar 114 Install Manual

Manual is about: Raymarine Raystar 114: Install Guide

Summary of Raystar 114

  • Page 1

    Distributed by any reference to raytheon or rtn in this manual should be interpreted as raymarine. The names raytheon and rtn are owned by the raytheon company..

  • Page 2: Combined Gps

    Combined gps & differential beacon receiver installation guide document number: 81151_3 date: 4th aug 1999.

  • Page 4

    Installation guide 1 important notice this device is only an aid to navigation. Its accuracy can be affected by many factors, including equipment failure or defects, environmental conditions and improper handling or use. It is the user’s responsibility to exercise common prudence and navigational ju...

  • Page 5

    2 raystar 114 check before going to sea • always check the installation before going to sea to make sure that it is not affected by radio transmissions, engine starting etc. • in some installations, it may not be possible to prevent the equipment from being affected by external influences. In genera...

  • Page 6

    Installation guide 3 2. Package contents checking your raystar 114 package the raystar 114 combined gps and differential beacon receiver package contains the following standard items: 1. Raystar 114 2. Beacon aerial 3. Ground screw with eyelet 4. Installation guide including warranty document items ...

  • Page 7

    4 raystar 114 3. Summary of features gps receiver type: 12 parallel channels frequency: 1575.42 mhz +/- 1 mhz (c/a code), l1 sensitivity: -130dbm signal acquisition: automatic time to first fix: 15 minutes maximum, typically 2 minutes standard gps position accuracy: 15 m rms. (l1, c/a code hdop spee...

  • Page 8

    Installation guide 5 differential beacon receiver frequency range: 283.5 to 325.0 khz msk bit rate: 100, 200 bps frequency resolution: 0.5 khz sensitivity: 2.5 mv/ m @10db snr @ 100 bps frequency selection: automatic / manual (user-selectable).

  • Page 9

    6 raystar 114 4. Raystar 114 installation the raystar 114 is designed to receive the signals emitted from the satellites in a direct path. Ideally, the unit should be mounted upright in a location that is open and clear of any masts, search lights, or other structures that could block the line-of-si...

  • Page 10

    Installation guide 7 ideally the cable should be run in a manner so that it can be hidden from view and, if possible, be in a direct path to the point of connection. It is important to keep the cable separated from other shipboard cables as much as possible to prevent interference pick-up. Caution c...

  • Page 11

    8 raystar 114 mounting the raystar 114 can be mounted on a pole. Alternatively, you can use a surface mount kit supplied by your local marine dealer. The aluminium base of the raystar 114 has been chromation treated to add toughness, resistance to wear and tear and resistance to corrosion of the ass...

  • Page 12

    Installation guide 9 if you have equipment with a dedicated gps socket that accepts this connector, you should use it. If it is not possible to use this connector, remove the 6-pin connector and re-connect the cable using a connector block, referring to the diagrams and connection tables below. As w...

  • Page 13

    10 raystar 114 using a connector block when connecting a raystar 114 into an existing instrument system or to certain raytheon chartplotters (eg. Raychart 520 or rl70rc) a connector block can be used to connect into the seatalk bus. If dc power is not already available via an existing seatalk instru...

  • Page 14

    Installation guide 11 note: a seatalk auxiliary junction box, which satisfies the above requirements, is available from your raytheon marine agent or is supplied with certain chartplotter products. For further technical information, please visit the raytheon marine web site at: www.Raymarine.Com nme...

  • Page 15

    12 raystar 114.

  • Page 16

    Limited warranty certificate raytheon marine company warrants each new light marine/dealer distributor product to be of good materials and workmanship, and will repair or exchange any parts proven to be defective in material and workmanship under normal use for a period of 2 years/24 months from dat...

  • Page 17

    Purchased from purchase date dealer address installed by installation date commissioned by owner’s name mailing address factory service centers united states of america raytheon marine company address as above uk, europe, middle east, far east raytheon marine company address as above united states o...