1. DL manuals
  2. Raymarine
  3. Switch
  4. SeaTalk HS
  5. User Manual

Raymarine SeaTalk HS User Manual

Other manuals for SeaTalk HS: Installation Manual, Installation Manual

Summary of SeaTalk HS

  • Page 1

    Distributed by any reference to raytheon or rtn in this manual should be interpreted as raymarine. The names raytheon and rtn are owned by the raytheon company..

  • Page 2: Seatalk

    Seatalk autopilot hand-held remote owner’s handbook document number: 81197-1 date: july 2001 81197_1.Book page 1 wednesday, august 1, 2001 11:19 am.

  • Page 3

    2 seatalk autopilot hand-held remote autohelm, hsb (high speed bus), sailpilot, seatalk and sportpilot are registered trademarks of raymarine ltd. Raymarine, ast (advanced steering technology), autoadapt, autolearn, autorelease, autoseastate, autotack, autotrim, fasttrim, gyroplus, raygyro, raypilot...

  • Page 4: Introduction

    Owner’s handbook 3 introduction the seatalk autopilot hand-held remote (part number a15002) is suitable for use with all seatalk compatible autopilots. It is supplied with: • 6 m (19.5 ft) of cable with a pre-fitted seatalk plug • a seatalk socket • a bracket for storing the hand-held remote note: t...

  • Page 5

    4 seatalk autopilot hand-held remote connecting the hand-held remote the hand-held remote is connected directly to raymarine autopilots or instruments using seatalk (the raymarine data interface system). The remote is supplied with a waterproof plug and socket that can be installed anywhere a remote...

  • Page 6

    Owner’s handbook 5 st1000, st2000 and st3000 autopilots 12v 12v st1000 or st2000 st3000 hand-held remote hand-held remote d177 cable (not supplied) 5a fuse red screen yellow red screen yellow d5683-1 red (+12 v) yellow (seatalk data) screen (seatalk ground) terminal stripes red (+12 v) yellow (seata...

  • Page 7

    6 seatalk autopilot hand-held remote st4000+ and st5000+ autopilots st4000+ and st5000+ control units have two parallel seatalk ports. You can connect the hand-held remote to either of these ports. Note: if any other seatalk instruments are connected to the st4000 or st5000 control units, the red wi...

  • Page 8

    Owner’s handbook 7 st6000+, st6001+, st7000+ and st7001+ pilots st6000 and st7000 autopilots the main difference when connecting older st6000 and st7000 autopilots is that you will need a seatalk cable with round plugs. Hand-held remote st7001+/st7000+ st6001+/st6000+ st6000+, st6001+, st7001+ or st...

  • Page 9

    8 seatalk autopilot hand-held remote sportpilot and sportpilot plus to connect the hand-held remote to the sportpilot you will need to purchase an appropriate seatalk interface cable (d229). The red core should also be fitted with a 5 a fuse. Note: if you intend to locate the remote close to the spo...

  • Page 10: Seatalk Cables

    Owner’s handbook 9 seatalk cables because you can use the hand-held remote with a wide range of raymarine autopilots, you will need to purchase the appropriate seatalk cable to connect the hand-held remote to the autopilot via the seatalk system. Conversion cables - flat moulded plug to round plug e...

  • Page 11

    10 seatalk autopilot hand-held remote installing the seatalk socket 1. Apply the template onto the bulkhead as required. 2. Drill the 18 mm ( 45 / 64 in) clearance hole and the two 2.5 mm ( 3 / 32 in) pilot holes. 3. Remove the template. 4. Cut and strip the seatalk cable (not supplied: see page 9)....

  • Page 12

    Owner’s handbook 11 installing the hand-held remote bracket the hand- held remote is supplied with a bulkhead-mounted storing bracket. This bracket should be attached to a convenient bulkhead using the 3 double-sided adhesive pads provided. Note: spare bulkhead brackets, part number d224, can be ord...

  • Page 13: Fault Finding

    12 seatalk autopilot hand-held remote fault finding all raymarine products are subjected to comprehensive test procedures prior to packaging and shipment. In the unlikely event that a fault does occur, the following check list should help to cure any problem. Led not illuminated • no power supply – ...

  • Page 14

    Owner’s handbook 13 drill 2.5 mm (3/32 inch) diameter hole (2 positions) drill 18 mm (23/32 inch) diameter hole seatalk socket template d5658-1 81197_1.Book page 13 wednesday, august 1, 2001 11:19 am.

  • Page 15

    14 seatalk autopilot hand-held remote 81197_1.Book page 14 wednesday, august 1, 2001 11:19 am.

  • Page 16: Important Note

    Raymarine emc guidelines emc installation & service guidelines important note all raymarine equipment and accessories are designed to the best industry standards for use in the leisure marine environment. When powered up, all electrical equipment produces electromagnetic fields. These can cause adja...

  • Page 17: Suppression Ferrites

    Raymarine emc guidelines • raymarine specified cables are used at all times. Cutting and rejoining these cables can compromise emc performance and so must be avoided unless doing so is detailed in the installation manual. • if a suppression ferrite is attached to a cable, this ferrite should not be ...

  • Page 18: Warranty Limitations

    Document number: 84064-8 april 2001 limited warranty certificate raymarine warrants each new light marine/dealer distributor product to be of good materials and workmanship, and will repair or exchange any parts proven to be defective in material and workmanship under normal use for a period of 2 ye...

  • Page 19: Factory Service Centers

    Factory service centers united states of america uk, europe, middle east, far east raymarine inc 22 cotton road, unit d nashua, nh 03063-4219, usa raymarine ltd anchorage park, portsmouth po3 5td, england telephone: +1 603 881 5200 fax: +1 603 864 4756 www.Raymarine.Com telephone: +44 (0)23 9269 361...