Raymarine SeaTalk-SeaTalk ng Handbook

Manual is about: SeaTalk-SeaTalk converter

Summary of SeaTalk-SeaTalk ng

  • Page 1

    Seatalk-seatalk converter ng handbook seatalk - seatalk ng converter.

  • Page 3

    Trademarks and registered trademarks autohelm, hsb 2 , raytech navigator, sail pilot, seatalk, seatalk ng , seatalk hs and sportpilot are registered trademarks of raymarine uk limited. Raytalk, seahawk, smartpilot, pathfinder and raymarine are registered trademarks of raymarine holdings limited. All...

  • Page 5: Chapter 1: Introduction

    Chapter 1: introduction seatalk - seatalk ng converter the seatalk - seatalk ng converter allows connection of a range of seatalk compatible products to the seatalk ng network. It contains electronics to bridge communications between the 2, allowing information to be shared. D11804-1 data types supp...

  • Page 6: Important Information

    Important information warning: potential ignition source this product is not approved for use in hazardous/flammable atmospheres. Do not install in a hazardous/flammable atmosphere (such as in an engine room or near fuel tanks). Caution: power supply protection when installing this product ensure th...

  • Page 7

    Note: where constraints on the installation prevent any of the above recommendations , always ensure the maximum possible separation between different items of electrical equipment, to provide the best conditions for emc performance throughout the installation product disposal dispose of this produc...

  • Page 8

    8 seatalk - seatalk ng converter.

  • Page 9

    Chapter 2: parts and accessories chapter contents • 2.1 parts supplied on page 10 • 2.2 seatalk - seatalk ng converter cables on page 11 parts and accessories 9.

  • Page 10: 2.1 Parts Supplied

    2.1 parts supplied the following items are included with the seatalk - seatalk ng converter kit. D11805-3 1 5 4 2 3 6 1 seatalk - seatalk ng converter 2 seatalk ng terminator (x2) 3 seatalk ng blanking plugs (x2) 4 400 mm (15 in) seatalk - seatalk ng converter cable. This cable connects the converte...

  • Page 11: 2.2 Seatalk - Seatalk

    2.2 seatalk - seatalk ng converter cables these cables are available as accessories. They are also included with some compatible products. D11824-1 1 2 description part no. 1 1 m (3.3 ft) seatalk - seatalk ng converter cable. This cable connects the converter to the first seatalk device on the spur....

  • Page 12

    12 seatalk - seatalk ng converter.

  • Page 13: Chapter 3: Installation

    Chapter 3: installation chapter contents • 3.1 typical systems on page 14 • 3.2 seatalk - seatalk ng converter connections on page 18 • 3.3 making seatalk ng connections on page 22 • 3.4 system checks on page 23 installation 13.

  • Page 14: 3.1 Typical Systems

    3.1 typical systems example: seatalk ng system with seatalk instruments d11806-1 enter cancel menu seatalk ng seatalk ng seatalk hs seatalk ng seatalk seatalk ng 12 / 24 v 1 2 enter cancel menu 3 7 4 5 6 smart pilot 14 seatalk - seatalk ng converter.

  • Page 15

    1 multifunction display with integrated gps (e.G. C-series widescreen) 2 seatalk ng autopilot controller and master instrument (e.G. St70) 3 seatalk repeat instruments (e.G st60+) 4 seatalk - seatalk ng converter 5 seatalk ng autopilot course computer 6 transducers connected via seatalk ng 7 seatalk...

  • Page 16

    Example: seatalk system with seatalk ng multifunction display d11812-1 seatalk hs s ea ta lk hs s ea ta lk hs seatalk ng seatalk ng seatalk / nmea 0183 seatalk s ea ta lk s ea ta lk 1 7 3 4 2 6 5 12 v 1 multifunction display 2 seatalk autopilot system (this cannot be connected to the converter.) 16 ...

  • Page 17

    3 seatalk spur containing instruments and mob system 4 seatalk spur containing rs125 gps 5 & 6 seatalk - seatalk ng converter 7 seatalk hs network (e.G. For digital sounder and radar) autopilot restrictions important: a seatalk autopilot or associated controller must not be connected to the seatalk ...

  • Page 18: 3.2 Seatalk - Seatalk

    3.2 seatalk - seatalk ng converter connections the converter connects in line as part of the seatalk ng backbone. It provides connections for seatalk ng and seatalk devices. D11807-1 1 2 3 4 5 1 blue — seatalk ng backbone connection 2 white — seatalk ng spur connection 3 yellow — seatalk spur connec...

  • Page 19

    Seatalk instrument connection to the seatalk ng converter d11808-1 12v 2 1 5 3 4 1 st60+ or st40 instruments connected on a seatalk spur. The spur may contain a maximum of 5 seatalk instruments. 2 seatalk - seatalk ng converter cable. 3 seatalk cable. 4 transducers connected directly to instrument. ...

  • Page 20

    3 1 2 d11822-1 1 2 3 4 1 lifetag base station 2 seatalk - seatalk ng converter cable 3 seatalk ng backbone 4 seatalk - seatalk ng converter connection colors 1 red (12 v) 2 screen 3 yellow (seatalk data) connection via a seatalk block the lifetag base station and converter can be connected using a s...

  • Page 21

    4 6 d11821-1 5 3 2 1 1 compatible seatalk device (e.G. An st60+ instrument) 2 lifetag base station 3 seatalk cable 4 seatalk ng backbone 5 seatalk to seatalk ng converter 6 seatalk - seatalk ng converter cable rs125 gps connection to seatalk - seatalk ng converter important: the gps connects directl...

  • Page 22: 3.3 Making Seatalk

    3.3 making seatalk ng connections 1. Rotate collar to unlocked position (so molded arrows are aligned). 2. Ensure cable end connector is correctly oriented, then fully insert. D11827-1 3. Rotate collar (2 clicks) until it snaps into the locked position (almost one quarter turn). D11828-1 cable types...

  • Page 23: 3.4 System Checks

    • other equipment and cables, • high current carrying ac and dc power lines, • antennae. Strain relief ensure adequate strain relief is provided. Protect connectors from strain and ensure they will not pull out under extreme sea conditions. Cable shielding ensure that all data cables are properly sh...

  • Page 24

    24 seatalk - seatalk ng converter.

  • Page 25

    Chapter 4: troubleshooting and support chapter contents • 4.1 system data troubleshooting on page 26 • 4.2 seatalk - seatalk ng converter led indications on page 27 • 4.3 raymarine technical support on page 27 troubleshooting and support 25.

  • Page 26

    4.1 system data troubleshooting aspects of the installation can cause problems with the data shared between connected equipment. Such problems, their possible causes and solutions are described here. Problem possible causes possible solutions check the data bus (e.G. Seatalk ng ) wiring and connecti...

  • Page 27: 4.2 Seatalk - Seatalk

    4.2 seatalk - seatalk ng converter led indications the led indicates seatalk ng and seatalk connection status. Led state (8 second cycle) seatalk ng connection status seatalk connection status healthy healthy not connected / fault not connected / fault not connected / fault healthy healthy not conne...

  • Page 28

    28 seatalk - seatalk ng converter.

  • Page 29

    Appendix a compatible seatalk devices the following seatalk instruments and equipment can be connected to the converter description st40 bidata st40 depth st40 speed st40 wind st40 compass st60+ tridata st60+ depth st60+ speed st60+ wind st60+ compass / heading st60+ rudder angle st60+ repeaters rs1...

  • Page 30

    Dimensions w 110 mm (4.3 in) x max. D 22 mm (0.9 in) x h 22 mm (0.9 in) 30 seatalk - seatalk ng converter.

  • Page 32

    Www.Raymarine.Com.