Raymarine SmartPilot X5 Sport Operating Manual - 3.1 Troubleshooting
19
Chapter 3: Troubleshooting & Maintenance
This chapter provides information to enable you to identify problems, interpret alarm
messages, maintain your SPX-5 Sport system and obtain product support.
Raymarine products are designed to provide many years of trouble-free operation.
They are also put through comprehensive testing and quality assurance procedures
before shipping.
However, if a problem occurs with your SPX-5 Sport system, use the troubleshooting
tables in this section to help identify the problem and provide a solution. If you cannot
resolve the problem yourself, refer to the product support information.
3.1 Troubleshooting
Symptom
Possible cause and remedy
Display is blank
No power – check the power and SeaTalk fuses on
Course Computer, then check main fuse/circuit breaker.
Data page display shows sta-
tionary dashes
The Pilot Controller is not receiving necessary data from
other instruments – check cabling.
Display shows rotating dashes
Compass calibration in progress (see
SmartPilot X-5
Sport Installation & Setup Guide
).
Displayed compass heading
does not agree with the boat’s
compass
You have not calibrated the compass. Carry out the devi-
ation and alignment procedures (see
SmartPilot X-5
Sport Installation & Setup Guide
).
Sport Drive getting hot
Manually check that the steering system operates com-
fortably and that it is not being overloaded.
Boat turns slowly and takes a
long time to come onto course
Manually check that the steering system operates com-
fortably and that it is not being overloaded. If this is OK,
the rudder gain may be too low. Complete AutoLearn or
increase gain setting (see
SmartPilot X-5 Sport Installa-
tion & Setup Guide
).
Boat overshoots when turning
onto a new course
Rudder gain too high. Complete AutoLearn or decrease
gain setting (see
SmartPilot X-5 Sport Installation &
Setup Guide
).
The SPX-5 Sport system ‘hunts’
when trying to position the rud-
der
Adjust the
RUDD DAMP
setting (see
SmartPilot X-5 Sport
Installation & Setup Guide
). Increase the damping one
level at a time until the autopilot stops hunting. Always
use the lowest acceptable value.
You cannot enter Seatrial Cali-
bration
Seatrial calibration lock is on – turn off the calibration pro-
tection feature in Dealer Calibration (see
SmartPilot X-5
Sport Installation & Setup Guide
).
The SPX-5 Sport system will not
‘talk’ to other SeaTalk instru-
ments
Cabling problem – make sure all the cables are con-
nected properly.
81293_3.book Page 19 Tuesday, August 25, 2009 7:53 AM